User guide

3. Be sure bracket is perpendicular to the ground with tab flush
against side of frame. Now drill a
1
⁄2” hole through frame and
insert
1
⁄2” X 4” bolt with a large
1
⁄2” washer with self-locking nut
and tighten.
4. To install the flat bracket on the drag link, position bracket so
that when the three large holes from a straight vertical line “I”
the two small holes are on the driver side (with upper hole of
the two small holes angling in toward the center of the
bracket “\”). See photo #2.
5. Insert tapered sleeve in tapered hole of drag link; insert a
1
⁄2” X 3” bolt from behind drag link, with a small
1
⁄2” washer
through drag link, next place both a large
1
⁄2” washer onto
bolt and a small
1
⁄2” washer, then the new bracket with a large
1
⁄2” washer and self-locking nut. Do not tighten this time.
See illustration #3.
6. Insert new U-bolt around drag link and
through new bracket. Install washers and
self-locking nuts and tighten.
Now tighten
bolt installed in Step 5 above.
7. To install shaft eye of stablilizer onto drag
link bracket, swing stabilizer up, align with
the upper hole on drag link bracket, and
install using one of the hardware paks
furnished (#P932).
8. Now install the second stabilizer to the
main frame bracket by inserting a
1
⁄2” X
2
1
⁄2” with a small
1
⁄2” washer through new bracket and stabilizer using another small
1
⁄2” washer
with self-locking nut and tighten. Install shaft eye of second stabilizer into lower hole of drag link
bracket using another hardware pak furnished (#P932).
9. Now check and re-tighten all nuts and bolts. After first 100 miles check and re-tighten all nuts
and bolts.
ILLUSTRATION #3
PHOTO #2
1
⁄/2 x 3” bolt
tapered sleeve
small
1
⁄2” washer
drag link
small
1
⁄2” washer
large
1
⁄2” washer
self locking nut
New bracket
large
1
⁄2”
washer
2.