Owners manual

1999-2004 Ford Superduty /
Excursion 4WD
Dual Steering Stabilizer Kit
Part # 7299
Installation:
1. Park the vehicle on flat level ground & set the emergency brake.
2. Place the tires / wheels to a straight forward position.
3. Remove OEM steering stabilizer & stabilizer mounting bracket.
4. Cut the OEM passenger side stabilizer bracket at the dotted line
with a hacksaw or grinder & discard. (See Photo # 1)
5. On the driver’s side, remove the nuts from the front u-bolt & install
the new Skyjacker bracket onto the u-bolt using the OEM
hardware. (Photo # 2)
6. Place the new Skyjacker main bracket under the tie rod. Notice the
four indentions on top of the tie rod (See arrows in Photo # 3). For
the correct alignment of the bracket, you must count over to the
third indention & place the first u-bolt onto the third indention.
Mount the other two u-bolts through the bracket.
7. Place the new Skyjacker shock boots onto the new steering
stabilizers & secure boots in place with the supplied boot ties.
Insert the 5/8” ID polyurethane bushings & P-932 studs into each
steering stabilizer eye. Pull the steering stabilizers out & fasten the
other end of the studs to the brackets. (See Photos # 4 & # 5)
8. Cycle steering left to right & check all components for adequate
clearance.
9. Re-torque all fasteners after the first 100 miles & periodically
thereafter.
Contents:
Part # Description Qty
7000 WHITE STEERING DAMPER 2
7299-MB MAIN BRKT FOR 7299 1
7299-DB DRIVERS BRKT FOR 7299 1
516X112X214U 5/16 X 1 1/2 X 2 1/4 U-BOLT ROUND 3
516CTN 5/16-18 COARSE N/I LOCK NUT 6
516SAEW 5/16 SAE WASHER 6
HOURGLASS 5/8 HOURGLASS 5/8 SHOCK BUSHING 4
140629 EB6 STUD BAG- P932 4
B10RS RED BOOT 2
BTIE RED BOOT TIE 2
HSS HYDRO SHOCK DECAL 2
I-7299 INST. SHEET FOR 7299 1
1
2
3
4
Photo # 1
Photo # 2
Photo # 3
Photo # 4
Photo # 5
Passenger side
Driver side
I-7299 REV1 3-11
www.skyjacker.com
Pg 1