Owners manual

Installation:
1. Park the vehicle on flat level ground & set the emergency
brake.
2. Set the tires / wheels in a straight forward position.
3. Remove the OEM steering stabilizer from the frame & from
the center steering link.
4. Install the 1 1/4” long bushing into the “body” end of the
new Skyjacker steering stabilizer & install the 1 1/4” long
sleeve into the bushing. (See Photo # 1)
5. Install the 5/8” hourglass bushing, which is 1 1/2” long, into
the shaft end of the new steering stabilizer. (See Photo # 2)
6. Install the tapered stud into the center steering link using
the supplied nut & washer & tighten in place. Slide the shaft
end of the steering stabilizer over the stud & tighten in place
using the supplied nut & washer. (See Photo # 2)
7. Attach the body end of the steering stabilizer to the OEM
mount on the frame using the OEM hardware.
8. After installation of the steering stabilizer, cycle steering left to tight & check all components for
adequate clearance. Re-tighten all hardware after the first 100 miles & periodically there after.
Seat Belts Save Lives, Please Wear Your Seat Belt.
2001- 2003 GM 2500 HD 4WD
2002- 2003 GM Hummer H2 4WD
OEM Replacement Steering
Stabilizer
Part # 7098
I-7098 REV1 3-11
7202WS WHITE STEERING DAMPER 1
HOURGLASS 5/8 HOURGLASS 5/8 SHOCK BUSHING 1
HG58125 HOURGLASS 5/8,1.25" LONG 1
P837 STAB TAPERED STUD/141264 1
403712 ES22 SLEEVE/1.25" LONG 1
B12RS RED BOOT, SMALL 1
BTIE RED BOOT TIE 1
HSS HYDRO SHOCK DECAL 1
I-7098 INST SHEET FOR 7098 1
Part # Description Qty
Contents:
Photo # 1
Photo # 2
www.skyjacker.com
Pg 1

Summary of content (2 pages)