Owners manual

87- 96 Jeep Wrangler YJ
Single Steering Stabilizer
Part # 7109
Installation:
1. Park the vehicle on flat level ground & set the emergency brake.
2. Turn the tires / wheels to a straight forward position.
3. Place the new Skyjacker straight frame bracket against the inside of the passenger side frame
directly above the drag link. Note: There may be a rubber frame shield, which is clipped at this
spot. If so, pull the shield at the corner & it should come loose. Mark a& drill the two holes in the
frame.
4. Move any hoses or lines that may get in the way of drilling as not to damage them in the drilling
process. Drill through the frame with a 3/8" drill bit & bolt the new bracket into place with the
supplied hardware. Re-connect frame shield.
5. Install the new skyjacker shock boot & boot tie onto the new Skyjacker steering stabilizer. Mount
the angled bracket to the drag link (this is the link going to the pitman arm), loosely, using the
supplied u-bolts, washers, & nuts. Attach the main end of the new steering stabilizer to the new
main bracket using the supplied hardware. Pull the steering stabilizer shaft out 4" & attach the
new steering stabilizer to the new drag link bracket using the supplied hardware. Tighten the
bracket at this time.
6. Re-tighten all bolts at this time. Re-tighten all bolts after the first 100 miles & periodically
thereafter.
Seat Belts Save Lives, Please Wear Your Seat Belt.
I-7109 REV1 3-11 Pg 1
Bill Of Material:
Part# Description Qty
7900WS WHITE STEERING DAMPER 1
BTIE RED BOOT TIE 1
B10RS RED BOOT 1
HSS HYDRO SHOCK DECAL 1
83031 MAIN BRKT - 7109 1
83161 UNIVERSAL TIE ROD BRACKET 1
38X312FTB 3/8 X 3 1/2 FINE THREAD BOLT 2
516X1X134U 5/16 X 1 X 1 3/4 U-BOLT RD 2
38FTN 3/8-24 FINE N/I LOCK NUT 2
38SAEW 3/8 SAE WASHER 2
516CTN 5/16-18 COARSE N/I LOCK NUT 4
516SAEW 5/16 SAE WASHER 4
STEM BUSH-SST STEM BUSHING-STEERING STAB. 4
142120 STAB WASH PKG - P889/145098 2
www.skyjacker.com