Owners manual

Installation:
1. Park the vehicle on flat level ground & set the emergency brake.
2. Place the tires / wheels to a straight forward position.
3. Attach the new Skyjacker steering stabilizer bracket into the OEM track bar mount. Attach the
new bracket to the OEM mounting hole using the OEM hardware. Hold the bracket straight so the
outer mounting tab can be marked & drilled. (See Photo # 1)
2. Using a 17/64" drill bit, drill the outer mounting tab hole. Attach the outer mounting tab using the
supplied 3/8" x 1" fine thread bolt, washers, & nut. Attach the new Skyjacker tie rod bracket to the
tie rod using the supplied 5/16" u-bolts, washers, & nuts. Do not tighten at this time. Assemble the
steering stabilizer. Install the boot first, then install the bushing & steel sleeve in the body end of
the stabilizer. Install the bushing & stud on the shaft end of the stabilizer.
3. Pull the shaft out of the stabilizer half way & attach the stabilizer to both brackets. Attach the
stabilizer to the axle bracket using the supplied 10mm bolt & nut. Attach to the tie rod bracket
using the supplied stud. It will be necessary to adjust the tie rod bracket so the stabilizer can be
installed with shaft pulled out half way. (See Photo # 2)
4. Cycle the tires / wheels left to right & check all hardware for adequate clearance. Re-tighten all
hardware after the first 100 miles & periodically there after.
1997-2006 Jeep Wrangler TJ
Steering Stabilizer
Part # 7112
I-7112 REV1 3-11
7400 WHITE STEERING DAMPER 1
JTBF JEEP TRACK BAR BRKT / FRONT 1
10MMX70MMB 10 X 70 METRIC BOLT/10.9 1
10MMN 10 MM N/I LOCKNUT 1
38X1FTB 3/8 X 1 FINE THREAD BOLT 1
38FTN 3/8-24 FINE N/I LOCK NUT 1
38SAEW 3/8 SAE WASHER 3
45313 ES2 SLEEVE/404242 1.42" 1
HOURGLASS 5/8 HOURGLASS 5/8 SHOCK BUSHING 2
83037 UNIVERSAL TIE ROD BRACKET 1
140629 EB6 STUD BAG - P932/140629 1
516X1X134U 5/16 X 1 X 1 3/4 U-BOLT ROUND 2
516CTN 516-18 COARSE N/I LOCK NUT 4
BTIE RED BOOT TIE 1
B10RS RED BOOT 1
HSS HYDRO SHOCK DECAL 1
Part # Description Qty
Part # Description Qty
Contents:
NOTICE: This steering stabilizer is only designed to work with the Skyjacker Adjustable Track Bar.
Outer Mounting Tab Bolt
Photo # 1
Photo # 2
Pg 1
www.skyjacker.com

Summary of content (2 pages)