Owners manual

Block & U-Bolt
Installation Instructions
I-BUK
1. Park the vehicle on flat level ground, block the front tires / wheels, & set the emergency brake.
2. Disconnect the rear shock from the axle. Raise the rear of the vehicle using a floor jack & support
the frame rails using jack stands. Remove the rear u-bolts & lower the axle away from the rear
springs to allow for installation of the lift block. Place the lift block between the leaf spring & the
axle tube. (If the vehicle is equipped with an OEM block, place the lift block under the OEM block
as shown in the diagram below). Skyjacker lift blocks are designed with a taper to set the
pinion angle. The lift block must be installed so the tallest portion is towards the rear of
the vehicle & the shortest portion towards the front.
3. Raise the axle making sure to line up the dial pin of the block with the center hole in the axle tube
& be sure that the tie bolt in the leaf spring lines up properly with the center hole in the block.
4. Install the new Skyjacker u-bolts & self-locking nuts. Torque to the specifications provided below.
5. Once the u-bolts are installed, lower the vehicle to the ground & reinstall the shocks.
6. Re-torque the u-bolts after the first 100 miles & periodically there after.
I-BUK REV1 3-11
Skyjacker
Self-Locking
Nuts
Skyjacker Ductile
Iron Lift Block
Rear Axle
Factory Block
(If Equipped)
Factory
Spring Plate
Leaf Spring
Skyjacker
U-Bolts
Torque Specifications:
1/2” U-Bolts = 75-80 Ft. Lbs.
9/16” U-Bolts = 85-90 Ft. Lbs.
5/8” U-Bolts = 100-110 Ft. Lbs.
www.skyjacker.com
Pg 1

Summary of content (2 pages)