User guide





Item #  Qty
916FTN 9/16 FINE THREAD LOCK NUT 8
Item #  Qty Item #  Qty
TU713STS TOYOTA 1"-3" ADJ FRT STRUT 2 HB-916 HDWR BAG: 9/16 FINE THR NUT 1




RBF125 1.25" FLAT REAR BLOCK 2 H7062 HYDRO SHOCK W/RED BOOT 2



916X212X834U 9/16 X 2 1/2 X 8 3/4 U-BOLT 4 I-TU730ST INST SHT: TU730ST/TU730STBH 1


Pg 2I-TU730ST

1. With the vehicle on flat level ground, set the emergency brake, &
block the rear tires / wheels.
2. Place a floor jack under the lower control arm’s front cross member
& raise the front of the vehicle. Place jack stands under the frame
rails, behind the front wheel wells & lower the frame of the vehicle
onto the jack stands.
3. Remove the front tires / wheels. (See Photo # 1)
4. Disconnect the OEM outer tie rods from the OEM steering
knuckles using a tie rod remover or other suitable tool.
5. Disconnect the lower strut mounts from the OEM lower A-arms &
disconnect the OEM sway bar end links from the OEM steering
knuckles.(See Photo #2).
6. Disconnect the OEM upper A-arms
from the OEM steering knuckles
using a ball joint remover or other
suitable tool. (See Photo # 3)


