User Manual

Before beginning the installation, thoroughly & completely read these instructions. Please refer to

the Parts List to insure that all parts & hardware are received prior to the disassembly of the vehicle.

If any parts are found to be missing, contact SKYJACKER

Customer Service at 318-388-0816 to

obtain the needed items. If you have any questions or reservations about installing this product,

contact SKYJACKER

Technical Assistance at 318-388-0816.

Installation:

1. With the vehicle on at level ground, set the emergency brake, & block the front & rear tires /

wheels.

2. Using the rear OEM upper A-arm bolts as a guide, align the two larger holes of the new Skyjacker

rear winch mount with the rear OEM upper A-arm bolts.

2012 Polaris Ranger 800

XP / Crew Rear Winch Mount

Installation Instructions

REQUIRED TOOL LIST:

• Safety Glasses

• Standard Wrenches & Sockets

• Drill & Assorted Drill Bits

• Torque Wrench

www.skyjacker.com

I-RWM101 REV2 2-12 Pg 1

Component Box Breakdown:

Part #: RWM101

Hardware Bag Breakdown:

Part # HB-RWM101

Item # Description Qty Item # Description Qty

CS2875 CRUSH SLEEVE / 2.875" 2 38FTN 3/8-24 FINE N/I LOCK NUT 4

38X114FTB 3/8 X 1 1/4 FINE THREAD BOLT 2 38SAEW 3/8 SAE WASHER 8

38X412FTB 3/8 X 4 1/2 FINE THREAD BOLT 2

Item # Description Qty Item # Description Qty

P12RWM-B 10-12 POL RGR REAR WINCHMT 1 I-RWM101 INSTRUCTION SHEET: RWM101 1

HB-RWM101 HDWR BAG: RWM101 WINCHMT 1

PAGE 1
2012 Polaris Ranger 800 XP / Crew Rear Winch Mount Installation Instructions www.skyjacker.com Required Tool List: • • • • Safety Glasses Standard Wrenches & Sockets Drill & Assorted Drill Bits Torque Wrench Before beginning the installation, thoroughly & completely read these instructions. Please refer to the Parts List to insure that all parts & hardware are received prior to the disassembly of the vehicle.
PAGE 2
3. Install the new Skyjacker upper crush sleeves (Part # CS2875) between each rear frame rail & install the new Skyjacker rear winch mount using the supplied 3/8" x 4 1/2" bolts, washers, nuts, & a 9/16" socket. (See Photo # 1) 4. Mark, center punch, & drill the new lower mounting locations for the new Skyjacker rear winch mount using a 3/8” drill bit. 5. Once drilled, finish installing the new Skyjacker rear winch mount to the vehicle using the supplied 3/8" x 1 1/4" bolts, washers, nuts, & a 9/16" socket.