Owners manual

Rear Installation:
1. Block the front tires / wheels, raise the rear of the vehicle, &
support using jack stands.
2. While supporting the rear differential, remove the rear tires /
wheels.
3. Remove the OEM rear shocks & disconnect the OEM brake line
bracket from the rear differential.
4. Remove the OEM rear u-bolts. Note: The rear differential will now be free to move, support
securely using a floor jack.
5. Lower the rear differential & install the new Skyjacker rear lift blocks between the axle pad &
OEM leaf spring. (See Photo # 7)
6. Raise the rear differential to the rear leaf springs. Note: Be sure the rear leaf spring center tie
bolts & block pins align in the proper holes & are completely seated.
7. Install the new Skyjacker u-bolts using the supplied 9/16" fine thread nuts.
8. Connect the OEM brake line bracket to the rear differential.
9. Install the new Skyjacker rear shocks using the OEM & supplied hardware.
10. Install the rear tires / wheels & lower the rear of the vehicle to the ground.
Final Notes:
• After the installation is complete, double check that all nuts & bolts are tight. Refer to the following
chart for the proper torque specifications. (Do not retighten the nuts & bolts where thread lock
compound was used.)
• With the vehicle placed on the ground, cycle the steering lock to lock & inspect the steering,
suspension, brake lines, front & rear drivelines, fuel lines, & wiring harnesses for proper operation,
tightness, & adequate clearance.
• Have the headlights readjusted to the proper settings.
• Have a qualified alignment center align the vehicle to the OEM specifications.
• After the first 100 miles, check all of the hardware for the proper torque & periodically thereafter.
Photo # 7
Pg 4I-TU730STB