Owner's manual

6. Install the new Skyjacker u-bolts. (See Photo # 34)

7. Install the new Skyjacker rear shocks using the OEM hardware.

8. Install the new Skyjacker E-brake cable brackets, ABS line bracket, &

rear brake line bracket to the differential using the supplied 5/16" x

3/4" bolts & nuts. (See Photos # 35, # 36, & # 37) Note: The OEM

rear brake line cable clamps must be inverted to raise the OEM

brake line up from the differential. (See Photo # 37)

9. Models equipped with an OEM carrier bearing will need to install the

new Skyjacker carrier bearing lowering spacers using the supplied

10mm x 80mm bolts & washers. (See Photo # 38)

10. Install the rear tires / wheels & lower the rear of the vehicle to the

ground.

FINAL NOTES:

• After the installation is complete, double check that all nuts & bolts are

tight. Refer to the following chart for the proper torque specifications.

(Do not retighten the nuts & bolts where thread lock compound was

used.)

• With the vehicle on the ground, cycle the steering lock to lock &

inspect the steering, suspension, brake lines, front & rear drivelines,

fuel lines, & wiring harnesses for proper operation, tightness, &

adequate clearance.

• H a v e t h e h e a d l i g h t s r e a d j u s t e d t o t h e p r o p e r s e t t i n g s .

• Have a qualified alignment center realign the vehicle to the OEM

specifications.

• Retorque all the bolts after the first 100 miles.

Photo # 34

I-TU761 Pg 9

Photo # 35

Photo # 36

Photo # 38

Photo # 37

Invert