Replacement Part List

Receiving Sensor
Avoid direct sunlight
WARNING
• Incorrect adjustment of garage door travel limits will
interfere with proper operation of safety reversal system.
• After making any adjustment, both safety beam sensors
and safety reversal system must be tested.
NOTE
Each programming step has a 30-second time limit for completion
after the function is initiated. Restart the step as many times as
necessary to complete the programming.
Each button on each remote must be programmed separately.
Step 1 – Programming remote / keypad
Blue LED
1. Press the [SET] button for one second,
and release the button when the
blue LED flashes slowly.
2. Program a Remote:
Within 30 seconds, press any button
on the remote that you would
like to program to the opener.
3. Once the button on the remote is
programmed, the blue LED will turn
off indicating the programming was
successful.
Blue
LED
1. Press and hold the [SET] button for 5
seconds until the blue LED stays on
and the red LED flashes quickly.
Release the [SET] button.
Note: Do not release the "SET" button
when you see blue LED light flashes
slowly.
2. Press the button until the door is
in fully open position.
Note: Use the DOWN button if the door
opens too far. Press UP / DOWN
button momentarily to adjust the
open travel limit as necessary.
3. Press the [SET] button to confirm the
door position.
Red
LED
SET DOOR TRAVEL LIMIT
(OPEN/CLOSE)
Step 2 – Programming the travel limits
22
PROGRAMMING