Replacement Part List

WARNING
1. Clear the In-Car Remote by holding on to the first and third buttons
for 20 seconds. Clearing the In-Car Remote will erase all previously
programmed garage door openers.
2. Press and hold the Skylink remote button for 10 seconds until the
LED flashes rapidly.
3. Choose the button on the In-Car Remote that will be used to open
the door. Press and hold this chosen button until the indicator on the
In-Car Remote blinks slow then fast. Once it blinks, release this button.
Before programming, make sure that people and objects are out
of the way of the garage door. The garage door will open and close
during programming. DO NOT proceed vehicle programming if
people or pets are in the path of the garage door.
Blue
LED
8. Press the wall button to open the
garage door to its fully open position.
9. The blue and red LEDs flash slowly.
10. The light will flash 3 times again.
11. Press the wall button to close
the garage door to its fully
closed position.
12. The blue and red LEDs will turn
off and emit one beep indicating
the programming was successful.
Red
LED
LEARN DOOR TRAVEL LIMIT
(OPEN/CLOSE)
LEARN DOOR TRAVEL LIMIT
(CLOSE/OPEN)
4. The blue LED stays on and the red
LED flashes slowly.
5. Press the button until the door is
in fully closed position.
Note: Door should rest on the floor until
the weather strip is partially compressed.
Damaged doors or uneven doors may
not seal properly. Repair these conditions
to achieve a proper seal. DO NOT set the
door close limit too far down that the rail
or door will bend or buckle.
6. Press the [SET] button again to confirm.
7. The blue and red LEDs stay on.
The light will flash 3 times when the
travel limit settings are completed.
SET DOOR TRAVEL LIMIT
(CLOSE/OPEN)
Blue
LED
Red
LED
Step 3 – Vehicle Programming (In-Car Remote)
23
PROGRAMMING