Instructions / Assembly

1. Run the wire from both sensors to the garage door opener. Attach the

wire to the wall and ceiling with the wire clips.

2. Remove insulation from each set of wires. Separate the wires. Twist

the two white non-marked wires together. Twist the two white marked

wires together.

3. Connect 2 pairs of twisted wires to the safety beam sensor

terminals on the garage door opener. To insert or remove

the wires from the terminal, push in the tab with a screwdriver tip.

Each pair of twisted wires can be connected to either terminal.

There are 2 options for connecting power:

1. AC Plug (Preferred & easiest)

1. Plug in the garage door opener into a grounded outlet.

2. Do not run garage door opener at this time.

2. Permanent Wiring by electrician

1. Cut existing power code outside chassis.

2. The wire connections must be made inside chassis and there must

be at least 6” of new power supply line wire inside chassis.

3. The opener must be grounded.

Step 12 – Connect power

WARNING

• Disconnect power before removing cover for permanent wiring.

• Never use an extension cord, 2-wire adapter or change plug in

any way.

• All wiring must be in compliance with all local electrical and

building codes.

Wire the Safety Beam Sensors

Permanent Wiring

Step 11 – Wire the Safety Beam Sensors

INSTALLATION