SDS

Material Safety Data Sheet (MSDS)
According to ISO 11014-2009
Report No.: DGC180409025KEA02 Date: Dec. 17, 2020 Page 7 of 10
Product Name: Lead-acid battery (2V/4V/6V/12V)
Section 7 - Handling and Storage
Handling Precautions: 1. With closed operation, provide a good natural ventilation. The operator
must go through specialized training, strict compliance with operating rules. 2. Keep away from heat,
ignition sources and no smoking. Use non-sparking ventilation explosion-proof type equipment. 3. Do
not crush, short (+) and (-) battery terminals with conductive (i.e. metal) goods. 4.Do not directly heat or
solder. Do not throw into fire or the place where may be submerged by water. 5. Do not be installed in
sealed equipment. 6. Make sure than the connection between batteries is correct. 7. Do not use the
battery in places where are full of dust (it should be regular checked when used in dusty environment). 8.
Use tools which are with insulating bush when handling. 9. Do not clean the battery with diluent,
gasoline, kerosene or composite liquid. 10. Slow handling when disassembly. 11. Do not cover the
battery with materials which can produce static electricity. 12. Battery do not be thrown away, put in as
much as possible separated from other garbage. 13. Pay special attention to be not smash foot.
Storage Precautions: 1. Stored in a cool, dry, well-ventilated place, keep batteries in non-conductive
(i.e. plastic) trays. Storage areas should be clearly marked "no obstacles." 2. Away from combustibles
areas. Away from heat, ignition sources. Avoid overheating and supercooling. Avoid contacting with
metal containers directly, adopt acid proofing and flame resistant materials. 3. Near the storage areas
have adequate fire extinguishers and spill clean-up equipment. 4. Avoid storing large quantities of
indoor, as much as possible stored in the isolation of the fire building. 5.Small parts, avoid contact with
children, to avoid being swallowed children.
Section 8 - Exposure Controls, Personal Protection
Engineering controls: Store batteries with adequate ventilation. Room ventilation is also required for
batteries utilized for standby power generation. Never recharge batteries in an unventilated, enclosed
space.
Personal Protective Equipment:
During installation, normal conditions of use or in the event of battery breakage, no exposure to lead and
lead containing battery paste. Exposure to sulphuric acid and acid mist might occur during charge.
Respiratory protection: NIOSH approved acid mist/organic vapor respirator, if OSHA PEL is exceeded.
Eye protection: Chemical goggles, safety glasses with side shields and or a full-face shield.
Hand protection: Rubber, PVC or neoprene gloves
This document cannot be reproduced except in full, without prior written approval of NTEK. Any unauthorized alteration, forgery or falsification of the content or appearance of
this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the
sample(s) tested and such sample(s) are retained for 30 days only.
NTEK Testing Technology Co., Ltd.
Address: Building 3, Meisaidaxin Park, Keji 8th Road, Songshan Lake High-Tech Industrial Development Zone,
Dongguan, Guangdong, China
Tel: [phone] Fax: [phone] Email: [e-mail] http://www.dgntek.org.cn