User's Manual Part 1

i
You have ten attempts to enter the cor-
rect security code. If you enter an incor-
rect security code, an error message
stating the number of attempts remain-
ing is shown for two seconds.
i
If the smart high line radio was last
switched off by switching the engine off,
it is then switched on again when the
engine is next started.
Deactivating
X
By switching to standby mode: press and
hold control knob W.
The smart high line radio always
switches to standby mode after the Good
Bye message.
Standby mode is terminated after a defined
time period (standby time). The device is
then switched off. You can set the standby
time (Y page 22).
In standby mode, the device is ready for use
quickly after being switched on again.
i
If the smart high line radio is operated
while the engine is switched off, the
device also goes into standby mode after
30 minutes. A message to this effect will
be shown first.
X
Without switching to standby mode: press
control knob W for approximately ten
seconds.
Mute
Audio and video source
X
Press control knob W briefly.
The audio or video source is muted. When
the sound is switched off, you will see
the , icon in the status bar.
i
You will still hear traffic announce-
ments and navigation announcements,
even if the sound is muted.
The , symbol cannot be seen on very
bright areas of the screen in video mode
and in the picture viewer.
Audio sources are muted automatically if
you activate voice control system for the
navigation (Y page 51).
Switching Traffic Programme and naviga-
tion announcements on/off
X
To switch the Traffic Programme on/off:
call up the "Settings" menu in radio mode
and press Traffic announcement
(Y page 70).
Depending on the previous status, the
function is switched on O or off ª.
X
To switch off navigation announce-
ments: press control knob W briefly dur-
ing a navigation announcement.
or
X
Switch off voice output via the "Set-
tings" menu (Y page 40).
X
To switch on navigation messages: press
on the arrow indicating the driving
direction on the map during route guid-
ance.
or
X
Switch on voice output via the "Settings"
menu (Y page 40).
Adjusts the volume
Adjusting the volume for the audio or video
source
X
Turn cVd the control knob.
Adjusting the volume for the traffic
announcements and navigation announce-
ments
Option 1
X
Turn cVd the control knob during a traf-
fic announcement or a navigation
announcements.
Option 2
X
Adjust the volume for the traffic
announcements (Y page 15) or the audio
fadeout in the "Volume settings" menu
>> smart high line radio.
15
Z