User's Manual

46
47
Yellow wire not connected or incorrect voltage.
Red wire not connected or incorrect voltage.
Check connections for proper voltage
(11~16VDC)
Unit will not turn on
(no power)
Black wire not connected
Check connection to ground
Fuse blown
Replace fuse
Unit has power
(but no sound)
Speaker wires not connected
Check connections at speakers
One or more speaker wires touching each
other or touching chassis ground
Insulate all bare speaker wires from each other
and chassis ground
Unit blows fuse
Yellow or red wire touching chassis ground
Check for pinched wire
Speaker wires touching chassis ground Check for pinched wire Incorrect fuse rating Use fuse with correct rating
Unit has audio
(but no video)
Parking brake safety circuit not connected
Parking brake not applied
Check connections at parking brake Apply parking brake
No video display
(when in reverse)
Reverse circuit not connected
Vehicle is not in reverse
Rear view set to OFF
Check connections at reverse lamp
Select reverse gear
Set rear view to ON - see page 14 for details
DVD does not start play-back
Physical defect in media
Wrong region
Check media for scratche
Use discs labeled "Region 1" or "All" only
IR remote does not work
Dead battery Replace battery
Excessive skipping
Unit is not mounted correctly
Check mounting sleeve
Physical defect in media
Check media for scratches
ERR-DISC appears
on display
Focus error or disc is in upside down
Press eject or RESET
Region code
error appears on display
Region code error
Use only DVDs labeled “Region 1” or “All” only
Front panel wil
l not open/close
Front panel obstructed
Remove the obstacle and press OPEN again to resume
the monitor open/close sequence
Weak station searching
Auto antenna is not fully extended
Connect the auto antenna control cable properly
Local function is activated
Turn LOCAL function OFF
Unit resets itself
when engine is off
Incorrect connection between ACC and
positive battery wire
Check wiring and correct
Message is longer than LCD can display.
Interruption during playback
Disc is dirty or scratched
Clean disk or replace
File is damaged/bad recording
Recreate disc with good files
Incorrect playback
message is played
iPOD Bluetooth
Reset Radio
iPod source not available
Incorrect cable connections
Check connection of the inport adapter to
rear of radio or connection of iPod to inport adapter
Cannot see video and
photo media on TFT screen
Wrong iPod Video Settings
Change iPod video settings to TV Out Check yellow RCA
cable from the inport adapter to the radio
All other errors
Please connect first appears
in the display
There is no mobile device connected
to the head unit
Pair and or connect a mobile device to the head unit as
described under Bluetooth Operation
Mobile device will not
connect to the head unit
Bluetooth function is not active
on the head unit
Activate Bluetooth function in General Setup
Bluetooth function is not active on
the mobile device
Refer to owner's manual of your mobile device
A mobile device is already connected to the
head unit. This time the head unit can only
be connected to one device at a time
Disconnect current mobile device first, then connect
the desired mobile device
ERROR! Connect Timeout
appears on display
The time limit for the pairing mobile device
has been reached
Pair the mobile device within 120 seconds
Pairing Fail appears
in display
The attempted pairing process has failed
Retry the pairing process again