User's Manual

10 11
6X80 Plus 6X80 Plus
LITHIUM BATTERY CONNECTION DIAGRAM
CONNECTING THE BATTERY
SKYRC 6x80 Plus comes with the built in switching power supply.
You can connect the AC power cord directly to the main AC socket.
(100-240V AC). For attaching directly to 12V car batteries. It is
critically important that you use a fully charged 13.8V car battery.
Important!!! Before connecting a battery it is absolutely essential to
check one last time that you have set the parameters correctly. If the
settings are incorrect, the battery may be damaged, and could even
burst into flames or explode. To avoid short circuits between the
banana plugs, always connect the charge leads to the charger first,
and only then to the battery. Reverse the sequence when
disconnecting the pack.
Using terminal
clip attaching
to car battery
Balance socket:
The balance wire attached to the battery must be connected to the
charger with the black wire aligned with the negative marking. Take
care to maintain correct polarity! (See the wiring diagram below.)
DC INPUT: The maximum charge circuit power is 80W.
AC INPUT: The maximum charge circuit power is 50W.
NOTE:
This diagram shows the correct way to connect your battery to the
SKYRC 6x80 Plus while charging in the balance charge program mode
only.
WARNING:
Failure to connect as shown in this diagram will damage this charger.
LITHIUM BATTERY CONNECTION DIAGRAM