User's Manual

B. Operating in DC mode
Please connect SKYRC Q200 with AC/DC power supply by supplied DC input cable. Also
you could use terminal clips with DC connectors, for attaching directly to 12V car
batteries. It is critically important that you use either a fully charged 13.8V car battery or a
high quality AC/DC power supply in the range of 11-18V DC output with minimum power
400W or higher to insure reliable performance.
Please refer to below table for detailed distributed power value in different channels.
CH A
CH B CH C CH D
DC Mode
Charging Power
0-100W 0-100W 0-50W 0-50W
AC Mode
Charging Power
50-100W 50-100W 0-50W 0-50W
Power Distribution
A+C=100W
B+D=100W
A+C=100W
B+D=100W
The total power of Channel A and Channel C is 100W; and the total power of
Channel B and Channel D is 100W.
Power distribution can be applied in certain two channels. Take Channel A for
example, it can be shared power with Channel C only, but can’t with Channel B or
Channel D.
There is min and max charging power limit in certain two channels. Take Channel
A and Channel C for example, Channel A can be set from 50W to 100W while
Channel C can be set from 0 to 50W.
Note 1:
Note 2:
Note 3:
Important Notice
Low quality DC power source may
damage your Q200 charger. We
recommend you to choose EFUEL
30A/540W Power Supply (SK-
200013).
· 12
Q200
OPERATING PROGRAM