User's Manual

ITEM
SELECTION DESCRIPTION
SYSTEM SETTING
NiMHSensitivity
D.Peak Default
NiCdSensitivity
D.Peak Default
Default: 4mV/Cell
5-15mV/Cell
Key Beep ON
Buzzer ON
OFF/ON
The beep sounds at every time touching
the buttons to confirm your action. The
beep or melody sounded at various times
during operation to alert different mode
changes.
Input. Power Low
Cut-Off 11.0V
10.0-11.0V
This program monitors the voltage of input
battery. If the voltage drops below the value
you set the operation forcibly terminated to
protect the input battery.
This program is for NiMH/NiCd battery only.
When the charger detects the delta peak
value reaches the value you set, the
charger will say the battery is fully charged.
Load Factory Set
Enter
Version
HW:1.00 FW: 1.10
Press ENTER to load factory default setting.
It indicates the hardware and firmware
version.
AC Max Power Set
100W
0-100W
It is to set the max AC power of the present
channel. Once you set it, the another
channel will take the rest.
Max Charge Power for CH A/CH B 100W
Max Charge Power for CH C/CH D 50W
BAL.Connection
ON
The default setting for charging Lithium
battery is using balance adaptor to connect
battery and charger in Charge, Fast
Charge, Balance Charge and Storage
modes. This function could be disabled
here.
OFF/ON
· 20
Q200