Instructions

R:3SER S:3SER
CONFIRM(ENTER)
Lp3s 1.5A 12.14V
BAL 000:50 00022
START/ENTER
R shows the number of cells detected by the charger and S is
the number of cells set by you on the previous screen. If the
two numbers are identical, press START/ENTER to start the
charging process.
Charging Status Monitor
During charge process, real-time status will be shown as seen
on the left.
Program Stop
During the charging process, press STOP to stop the charging process.
Program Complete
Lithium Battery Program(LiPo/LiFe/Lilon/LiHV)
BATTERY CHECK
WAIT...
The charger is detecting the battery cell.
R shows the number of cells detected by the charger and S
is the number of cells set by you on the previous screen. If
the two numbers are not identical, press STOP to go back
to the previous screen to recheck the number of cells of the
battery pack that you set before going ahead.
R:3SER S:3SER
CANCEL(STOP)
[ END: FINISH ]
16.8V 2600mAh
[ Time: 00: 45: 32 ]
16.8V 2600mAh
Once the battery is fully charged, the screen will read “END:
FINISH” and the charger will emit a ringing sound. The
charger also displays battery voltage, charged capacity and
elapsed time.
· 14
T200
Please scan and watch the tutorial
video about how to charge LiPo
battery in balance mode.
Video
Tutorial