Installation Instructions
LAUNCH
A
U
T
O
MA
N
U
A
L
F
L
Y
IN
G M
O
D
E
R
L
LAUNCH
LAND
OFF ON
01942
Front
B
A
A
B
POWERING UP AND PAIRING REMOTE
• Reset controller to
factory settings:
Hold F Trim, B Trim,
and Power for
3 seconds.
Forward/
Back ward Trim
Power
Stunt Button
Auto Mode Indicator
Manual Mode Indicator
Rotation Trim
Left/Right Trim
FLIGHT BASICS
Press LAUNCH to automatically launch a few feet off the ground.
Move LEFT (Throttle) thumbstick up or down to make drone fly
higher or lower and left or right to rotate.
Use RIGHT (Directional) thumbstick to fly forward,
backward, left or right.
Press LAND to automatically land.
Rotate
Left
Rotate
Right
Up
Down
FLIGHT CONTROLS
ONE TOUCH STUNTS
Fly RightFly Left
Fly Forward
Fly Backward
REPLACING DAMAGED BLADES
AUTO AND MANUAL FLIGHT MODES
Using a fork or tool,
gently pry the blade
from the motor shaft.
To make flying easier, place the drone on the ground in front of you
with the drone facing away from you (green blades forward). You
should be facing the same way the drone is facing.
Turn on controller. (Before initial use,
install new batteries into controller.
See Rever s e.)
FLYING GUIDE
NANO DRONE
DASH
Place the drone on level surface for
calibration.
R
L
AU
T
O
MA
NUA
L
F
LYING M
O
D
E
LAUNCH
LAND
When LEDs turn solid, the drone is ready to fly.
AUTO mode is best for new
pilots. Begin by pressing the
LAUNCH button for takeoff.
The drone will hold its altitude,
and gradually fly up or down
when you press up or down on
the left thumbstick.
MANUAL mode is better for
experienced pilots. When the
left thumbstick is pushed all
the way up the drone will spin
its motors as fast as it can
while maintaining stability, and
when the left thumbstick is
pushed all the way down the
motors will stop spinning
completely.
Turn the drone on. (Be sure that
drone is completely charged.
See reverse.)
NOTE:
Once a stunt has been initiated, DO NOT adjust Throttle or press any other controls until the stunt has been completed.
CAUTION!
The drone should be flying at least 6 feet in the air with a minimum clearance of 6 feet in all directions before
attempting stunt functions.
FLIP IN 4 DIRECTIONS
1 Bring the drone to a mid-air hover without flying in any
direction. Remove finger from the RIGHT thumbstick.
2 While hovering, press and hold the STUNT button.
3 Then quickly tap the RIGHT thumbstick in the direction
you want the drone to flip.
BARREL ROLL LEFT OR RIGHT
While flying forward (or reverse), tap the STUNT button.
R
R
L
LAUNCH
LAND
R
L
AU
T
O
M
A
N
UA
L
F
LIGHT
MOD
E
LAUNCH
LAND
R
L
A
U
T
O
M
A
N
U
A
L
F
L
IGHT
M
OD
E
LAUNCH
LAND
Flight Mode
LAUNCH/LAND BUTTON
PRESS TO LAND
PRESS TO LAUNCH
If for any reason you need to immediately stop the drone, hold down the stunt
button (for drones that don't have a stunt button, use the video button) and
move both thumbsticks down and away from the center of the controller.
Alternatively you can use the left thumbstick to land
the drone. Hold the left thumbstick all the way down
for about 2.5 seconds after the drone has safely
reached the ground, and the motors will stop spinning.
To change the speed of
the drone, hold STUNT,
, and . The LED on
the controller will blink
once for slow, twice for
medium, and three
times for fast.