Operation Manual

STEREO INPUTS
The system has two stereo inputs and these are used primarily for MP3 or CD players but
could be used with the stereo output of an electronic keyboard, instrument pre-amp or
processor, or an electronic drum machine. The inputs labeled “STEREO IN 5/6” offer the
option of using ¼" phone plugs. The input labeled “STEREO IN 7/8” is a RCA stereo input.
LEFT/RIGHT speaker outputs - These 6.35mm outputs on the right side of the mixer
should only be connected to the system speakers and under no condition should they be
connected to the input of another electronic device.
These outputs carry power and as such could damage the electronic device. Only use
“unshielded ” speaker cables (like the cables provided with your system).
MASTER VOLUME and “PEAK LED LADDER”
Your system is equipped with a “Master Volume” that controls the overall
output volume of the system and a 5 light “Peak LED Ladder” that gives you
a visual display of how much power you are using (think of the speedometer
on your car). The red or top LEDs on the ladder indicate that you are approaching
the maximum output by blinking or, when it stays on constantly, indicates you
have reached the maximum output. As a frame of reference if a channel volume
is on “7” and the “MASTER VOLUME” is on “7” you will have reached the
maximum output before distortion is audible.
ECHO EFFECT
As a basic place to start turn the EFFECT control to “5” on the appropriate channel. If there are undesired effects
then turn the Echo and Depth to suit your taste. Located on each mono input strip is a control labeled “EFFECT”.
This control determines the amount of effect for that specific channel.
EQUALIZER
Pls see the diagram next to the panel for equalizer mode
selection.
MP3 Panel with USB & SD Slots and Display.