Installation and Operating Instructions

Skytech: CON1001TH-1
REV. 2-22-22 Page 4
RECEIVER FUNCTIONS:
• With the slide switch in the REMOTE position, the system will
only operate if the remote receiver receives commands from the
transmitter.
• Upon initial use or after an extended period of no use, the ON
button may have to be pressed for up to three seconds before
activating servo motor. If the system does not respond to the
transmitter on initial use, see LEARNING TRANSMITTER TO
RECEIVER.
• With the slide switch in the ON position you can manually turn ON
the system.
• With the slide in the OFF position, the system is OFF.
• It is suggested that the slide switch be placed in the OFF position
if you will be away from your home for an extended period of time.
• Placing the slide switch in the OFF position also functions as a
safety “lock out” by both turning the system OFF and rendering the
transmitter inoperative.
Wire terminals
Remote Receiver
Receiver
Slide
Button
REMOTE
OFF
ON
LEARN
INSTALLATION INSTRUCTIONS
DO NOT CONNECT REMOTE RECEIVER DIRECTLY TO 110-120VAC POWER. THIS WILL BURN
OUT THE RECEIVER. FOLLOW INSTRUCTIONS FROM MANUFACTURER OF GAS VALVE FOR
CORRECT WIRING PROCEDURES. IMPROPER INSTALLATION OF ELECTRIC COMPONENTS
CAN CAUSE DAMAGE TO GAS VALVE AND REMOTE RECEIVER.
WARNING
The remote receiver can be mounted on or near the replace hearth. PROTECTION FROM EXTREME HEAT IS VERY
IMPORTANT. Like any piece of electronic equipment, the remote receiver should be kept away from temperatures
exceeding 130º F inside the receiver case. Battery life is also signicantly shortened if batteries are exposed to high
temperatures.
HEARTH MOUNT
The remote receiver can be placed on the replace hearth or under the
replace, behind the control access panel. Position where the ambient
temperature inside the receiver case does not exceed 130º F.
NOTE: Black Button is used on Hearth Mount Applications
Wire terminals
Remote Receiver
Receiver
Slide
Button
REMOTE
OFF
ON
LEARN