Installation and Operating Instructions

Skytech: CON1001TH-1
REV. 2-22-22 Page 7
TROUBLE SHOOTING
If you encounter problems with your replace system, the problem may be the replace itself or it could be with the
CON1001TH-1 remote system. Review the replace manufacturer’s operation manual to make sure all connections are
properly made. Then check the operation of the remote in the following manner:
• Make sure the batteries are correctly installed in the RECEIVER. One reversed battery will keep receiver from
operating properly.
• Check battery in TRANSMITTER to ensure contacts are touching (+) and (-) ends of battery. Bend metal contacts in
for tighter t.
• Be sure RECEIVER and TRANSMITTER is within 20 to 25-foot operating range.
• Clear Codes: Memory in the receiver might be full if the learn button is pressed too many times. If this happens it will
not allow any more codes to be learned and no audible beep will be heard. To clear memory, place the receiver slide
switch into the REMOTE position. Press the learn button and release after 10 seconds. You should hear three (3)
long audible beeps indicating all codes have cleared. You can now “learn” the transmitter to the receiver as described
in the General Information Section.
• Keep RECEIVER from temperatures exceeding 130°F. Battery life shortened when ambient temperatures are above
115°F.
• If RECEIVER is installed in tightly enclosed metal surround, the operating distance will be shortened.
SPECIFICATIONS
BATTERIES: Transmitter (2) 1.5 volt AAA batteries
Remote Receiver 6V - 4 ea. AA 1.5 Alkaline
Operating Frequency: 303.8 MHZ