User's Manual

SKYTECH 1001SR/P TH
REV. 09/02
Page 2 of 6
SETTING
0
F /
0
C SCALE
The factory setting for temperature is
0
F. To change this setting to
0
C, first
• Press the ON/HI key and the LO/OFF key on the transmitter at the same
time this will change from
0
F to
0
C. Follow this same procedure to
change from
0
C back to
0
F.
MANUAL FUNCTION
To operate the system in the manual mode do the following.
ON OPERATION
Press and hold the ON/HI key until the appliance flame comes on and reaches
the desired flame height or is at full on. During this time the LCD screen will
show HI, after 3 seconds the LCD screen will default to display room
temperature and the word TEMP will show.
OFF OPERATION
Press and hold the LO/OFF key until the appliance flame reaches the desire
flame height or completely shuts off. During this time the LCD screen will show
LO, after 3 seconds the LCD screen will default to display room temperature
and the word TEMP will show.
THERMOSTAT FUNCTION
SETTING DESIRED ROOM TEMPERATURE
This remote control system can be thermostatically controlled when the
transmitter is in the THERMO mode (SET must be displayed on the screen).
To set the DESIRED room temperature,
Press the MODE key the display will show the words SET TEMP and the
temperature display will began to flash.
Press and hold the SET key until the desired set temperature is reached then
release the SET key.
Press the MODE key to disengage the thermo mode. The word ROOM on the
LCD screen will not show when the thermo is not in operation.
NOTE: The highest SET temperature is 99
0
Fahrenheit (32
0
Celsius) and the
lowest temperature (45
0
F, or 6
0
C ).
TEMP
TEMPSET
THERMO SET
SCREEN DURING
ADJUSTING TO ON
SCREEN DURING
ADJUSTING TO OFF
TEMP
SCREEN AFTER 3
SECOUND DEFAULT
ROOM TEMP
THERMO OFF
ROOM TEMP
THERMO ON
TEMP
SCREEN AFTER 3
SECOUND DEFAULT