User's Manual

Skytech 3001
REV 12/01
Page 3 of 8
3. To store the “swing number press the SET button or allow 15 seconds to lapse, and the new “swing number’ will be automatically
programmed.
MANUAL CHECK OF “ SWING” OR TEMPERATURE DIFFERENTIAL
The operation of the factory set “THERMO SWING” can be checked by adjusting the SET TEMP 2
0
F
above or below the room temperature.
This will cause the system to turn ON or OFF. Normally the system will only respond to temperature changes every two minutes. Manually
changing the SET temperature will activate the system in less than 10 seconds. IF the “SWING” is changed, then a new room temperature
0
F
.
SETTING THE COUNTDOWN TIMER
This remote control system can operate with a built-in countdown timer when the transmitter is in the ON or
THERMO modes (
THERMO or ON must be displayed on the screen).
1. Press and release the TIME R/TIME button on the transmitter. The word TIMER and 0:15 flash on the
screen.
2. Press the UP or DOWN button on the transmitter to begin advancing through each of the countdown
time options. Available countdown times are 15 minutes, 30 minutes, 45 minutes, 1 hour, 1 hour 30
minutes, 2 hours, 2 hours 30 minutes, and each additional half-hour up to nine hours.
3. To set the TIMER press the SET button on the transmitter if the system is ON. It will remain on until the
time has expired. If the system is in the THERMO mode, it will cycle on and off as the room
temperature requires until the “time” has expired.
OPERATIONAL NOTE:
When the timer is used in the THERMO mode, the THERMO operation will discontinue when the “time” has expired.
LOW/BATTERY INDICATOR
The word LOW outlined by a battery on the left side of the LCD screen will appear when battery power has
dropped significantly. At this time, approximately two weeks of battery power remains until the transmitter
may experience partial or complete loss of functions. NOTE: A reversed battery will activate the LOW
battery icon.
CHILDPROOF “LOCK-OUT” – (CP)
This SKYTECH remote control includes a CHILDPROOF “LOCK-OUT” feature that allows the user to “LOCK-OUT” operation of the appliance,
from the TRANSMITTER.
SETTING “LOCK-OUT” –(CP)
1. To activate the “LOCK-OUT” feature, press and hold the UP and TIMER/TIME buttons, together, for 5
seconds. The letters CP will appear in the TEMP frame on the LCD screen.
•
To disengage the “LOCK-OUT”, press and hold the UP and TIMER buttons, together for 5 seconds or
more, and the letters CP will disappear from the LCD screen and the transmitter will return to its
normal operating condition.
NOTE: If the appliance is already operating in the ON or THERMO MODES, engaging the “LOCK-OUT” will not cancel the operating MODE.
Engaging the “LOCK-OUT” prevents only the manual operation of the TRANSMITTER. If in the auto modes, the THERMO operation will
continue to operate normally. To totally “LOCK- peration of the TRANSMITTER’S operating signals; the transmitter’s MODE must
be set to OFF.
TRANSMITTER
The SKYTECH remote control operates, on RF (radio frequency) signals that are sent by the TRANSMITTER (remote) to the RECEIVER that
operates the appliance. It is recommended that the TRANSMITTER always be located within the 20 foot operating range, preferably in the
same room in which the appliance is located.
THERMO UPDATING FEATURE –TRANSMITTER – (T/S –TX)
This SKYTECH remote control has a THERMO UPDATING Feature built into its software. The THERMO UPDATING Feature operates in the
following manner, but only in the THERMO MODES: