User's Manual

Slide down the plastic cover on the front of
the transmitter to expose the “SET” buttons.
The Slide cover protects the SET buttons from
being changed accidentally. Close the cover
after completing the following
settings/programming.
Flashing numbers on the display indicate the
system is awaiting user input, such as using
the UP and DOWN buttons to program a new
setting. If no change is made to flashing digits within 15 seconds, the system will
complete the procedure last programmed and reset the display to its normal state.
1. Press and hold the TIME /TIMER button
on the transmitter for more than two
seconds. The hour digit(s) will begin
flashing.
2. Press the UP or DOWN button until the
desired hour is displayed in AM or PM.
3. After setting the desired hour, press and
release the TIME/ TIMER button again to
set the minutes; the minute digits will
begin flashing.
4. Press the UP or DOWN button until the
desired minutes are displayed.
5. Press the SET button on the transmitter to
stop the time digits from flashing and set
the time. The time digits will cease
flashing, indicating the clock has been successfully set.
SETTING
℉
/
℃
SCALE
The factory setting for temperature is
℉
. To change this setting to ℃, first press and
hold the UP button and the DOWN button on the transmitter at the same time. Follow
this same procedure to change from ℃ back to
℉
. When changing between the
℉
and ℃ scales, the temperature in the SET frame defaults to the lowest temperature
(45
℉
, or 8
℃
). The highest SET temperature is 99° Fahrenheit (37° Celsius ).
F
ON
OFF
THERMO
ROOM
PM
FLAME
SET
SETTING THE CLOCK
TIMER
F
DOWN
TIME/TIMER
UP
SET
MODE
BUTTON SETTINGS