User's Manual

SETTING DESIRED ROOM TEMPERATURE
This remote control system can be
thermostatically controlled when the
transmitter is in the THERMO mode
(THERMO must be displayed on the
screen). To set the DESIRED room
temperature, press the MODE button to
place the transmitter into THERMO mode,
then press the UP or DOWN button to
select the desired room temperature. The
highest SET temperature is 99°
Fahrenheit (37° Celsius ).
OPERATIONAL NOTE: TO CONSERVE BATTERY POWER, CHANGES IN
ROOM TEMPERATURE ARE AUTOMATICALLY UPDATED EVERY TWO
MINUTES TO THE TRANSMITTER.
The Thermo Mode on the transmitter operates the appliance whenever the ROOM
TEMPERATURE varies a certain number of degrees from the SET TEMPERATURE.
This variation is called the “SWING” or TEMPERATURE DIFFERENTIAL. The
normal operating cycle of an appliance may be 2-4 times per hour depending on how
well the room or home is insulated from the cold or drafts. A smaller “swing number”
increases the number of cycles so the room temperature is more constant. A larger
“swing number” decreases the number of cycles, which saves energy, in most cases.
The factory setting for the “swing number” is 2. This represents a temperature
variation of +/-2
℉
(1
℃
) between SET temperature and ROOM temperature, which
determines when the fireplace will be activated. The “SWING” number values are:
1=
±
1
℉
(.5
℃
), 2=
±
2
℉
(1
℃
) and 3=
±
3
℉
(1.6
℃
).
SETTING THE TEMPERATURE SWING (TEMPERATURE DIFFERENTIAL)
1. To change the temperature “SWING”
setting (1-3), press the TIME/ TIMER and
DOWN buttons simultaneously to display
the current “SWING” setting in the SET
TEMP frame. The letter “S” will display in
the ROOM TEMP frame on the LCD
screen.
2. Press the UP or DOWN button to change
F
ON
OFF
THERMO
F
ROOM
PM
FLAME
SET
TIMER