User's Manual

the temperature differential or “SWING” (1-3). See above for 1-3 “SWING”

temperature valves.

3. To store the “swing number” press the SET button or allow 15 seconds to lapse,

and the new “swing number” will be automatically programmed.

MANUAL CHECK OF “SWING” OR TEMPERATURE DIFFERENTIAL

The operation of the factory set “THERMO SWING” can be checked by adjusting the

SET TEMP 2

℉

above or below the room temperature. This will cause the system to

turn OF or OFF. Normally the system will only respond to temperature changes every

two minutes. Manually changing the SET temperature will activate the system in less

than 10 seconds. IF the “SWING” is changed, then a new room temperature

differential will respond. Factory setting of “SWING” temperature is 2

℉

SETTING THE COUNTDOWN TIMER

This remote control system can operate

with a built-in countdown timer when the

transmitter is in the ON or THERMO

modes (THERMO or ON must be

displayed on the screen).

1. Press and release the TIME/ TIMER

button on the transmitter. The word

TIMER and 0:15 flash on the screen.

2. Press the UP or DOWN button on the

transmitter to begin advancing through

each of the countdown time options. Available countdown times are 15 minutes,

30 minutes, 45 minutes, 1 hour, 1 hour 30 minutes, 2 hours, 2hours 30 minutes,

and each additional half-hour up to nine hours.

3. To set the TIMER press the SET button on the transmitter if the system is ON. It

will remain on until the time has expired. If the system is in the THERMO mode,

it will cycle on and off as the room temperature requires until the “time” has

expired.

OPERATIONAL NOTE: When the timer is used in the THERMO mode, the

THERMO operation will discontinue when the “time” has expired.

LOW/BATTERY INDICATOR

ROOM

TIMER

FLAME

SET

OFF

THERMO