User's Manual

Dexen Level 2 User’s Manual

Transmitter –Dexen Level 2

This remote control SYSTEM offers

the user a battery-operated remote

control that operates most millivolt

gas valves used in some heater

rated gas logs， gas fireplaces and

other gas heating appliances.

The transmitter operates on (2) 1.5V

AAA batteries.

It is recommended that ALKALINE

batteries always be used for longer

battery life and maximum

operational performance.

Before using the transmitter， install the (2) AAA transmitter batteries into the battery compartment. (Use

caution that batteries are installed in the proper direction)

KEY SETINGS



- Operates unit to on/off

position， Manually ON/OFF.

 - Operates unit to

flame position for Hi / Middle / Low.



- Operates unit to

enable/disable Continuous Pilot.



- Operates unit to lock /

unlock the key pad behind the

transmitter.

Note: The indicatory LED will be shined by key pressed during the key unlock.

15.19 FCC Compliance Statement

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.

15.21 Statement

Changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

PAGE 1
Dexen Level 2 User’s Manual Transmitter –Dexen Level 2 This remote control SYSTEM offers the user a battery-operated remote control that operates most millivolt gas valves used in some heater rated gas logs， gas fireplaces and other gas heating appliances. The transmitter operates on (2) 1.5V AAA batteries. It is recommended that ALKALINE batteries always be used for longer battery life and maximum operational performance.
PAGE 2
ON OPERATION Press the key the appliance flame will come on. OFF OPERATION Press the key again the appliance flame will shut off. High / Low OPERATION When the Key is first pressed the output will be on High. Then the key is pressed again that will change into Low. A second push will turn the burner/valve into High. Continuous Pilot OPERATION When the the key is first pressed the output will enabled continuous pilot. Then key is pressed again that will disabled continuous pilot.