User Guide

FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODI-
FICATIONS TO THE EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT
For Technical Service, call:
U.S. INQUIRIES
888/672-8929 or 260/459-1703
Web site: www.skytechsystem.com
CANADIAN INQUIRIES
877/472-3923
MANUFACTURED EXCLUSIVELY FOR SKYTECH II, INC
REV 4/15/11 Page 4
TRANSMITTER WALL CLIP
The transmitter can be hung on a wall using the clip provided.
Wood - Drill 1/8’’ pilot holes and install with screws provided.•
Plaster/Wallboard - Drill 1/4’’ holes, use a hammer to tap in the two plastic anchors, then •
install with the screws provided.
WALL CLIP
SLOT
WALL CLIP
BATTERY
COMPARTMENT
BATTERY LIFE
Life expectancy of the alkaline batteries in the transmitter and receiver should be at least 12 months. Check and replace all batteries:
Annually.•
When operating range becomes reduced.•
When transmissions are not received by the remote receiver.•
If the remote receiver batteries measure less than 5.3 volts (all four batteries in combination).•
If the hand held transmitter battery measure less than 9.0 volts.•
TROUBLE SHOOTING
Ifyouencounterproblemswithyourreplacesystem,theproblemmaybewitheitherthereplaceitselforwiththeremote.Review
thereplacemanufacturer’soperationmanualtomakesureallconnectionsareproperlymade.Thenchecktheoperationofthe
remote in the following manner:
Make sure all batteries are correctly installed in the transmitter and receiver. Also check that the batteries are fully charged.•
Checkbatteriesintransmittertomakesurecontactsaretouching(+)and(-)endsofbattery.Bendmetalcontactsinfortightert.•
Be sure receiver and transmitter is within 20-25 feet operating range.•
Keep receiver from temperatures exceeding 130 degrees F. Battery life will be shortened if exposed to high temperatures.•
If receiver is installed in a tightly enclosed metal surrounding, the operating distance will be shortened.•
Makesurethehand-heldtransmitterandremotereceiverarecommunicatingproperly(seeLEARNINGTRANSMITTERTORE-•
CEIVERsection).
Clear Codes: Memory in the receiver might be full if the learn button is pressed too many times. If this happens it will not allow •
anymorecodestobelearnedandnoaudiblebeepwillbeheard.Toclearmemory,placethereceiverslideswitchintotheRE-
MOTEposition.Pressthelearnbuttonandreleaseafter10seconds.Youshouldhearthree(3)longaudiblebeepsindicatingall
codeshavecleared.Youcannow“learn”thetransmittertothereceiverasdescribedintheGeneralInformationSection.
Skytech 1001-A