User Manual

Section 2 - Pre-Operation and Inspection

2-12 31200352

2.3 WALK-AROUND INSPECTION

Begin your walk-around inspection at item 1, as noted below. Continue to your right

(counterclockwise when viewed from top) checking each item in sequence.

INSPECTION NOTE: On all components, make sure there are no loose or missing

parts, that they are securely fastened and no visible leaks or excessive wear exists

in addition to any other criteria mentioned. Inspect all structural members including

attachment for cracks, excessive corrosion and other damage.

1. Boom Sections and Lift, Tilt, Extend/Retract, Compensating (Slave) Cylinders

• Check front, top, side and rear wear pads for presence of grease.

• Pivot pins secure; hydraulic hoses undamaged, not leaking.

2. Left Outrigger

(10042 & 10054) - Pins secure; hydraulic hoses and cylinder

undamaged, not leaking.

3. Front Axle

- Steer cylinders undamaged, not leaking; pivot pins secure;

hydraulic hoses undamaged, not leaking.

OH3781