Manual

ManualsBrandsSkyTrak ManualsSpecial machinery10054 Operation Manual

Model 10054 Rev 3/02

Operation

Quick Attach

This vehicle is equipped with a quick attach system for easy attachment

changing.

Attachment Removal

Be sure you are performing this procedure on level ground.

1. Place the travel select lever in (N) NEUTRAL, come to a complete

stop, move the neutral lock lever to NEUTRAL LOCK position and

engage the parking brake switch.

2. Extend the boom approximately 10 feet (3 meters) and tilt the car-

riage backward.

3. Exit the vehicle using the hand holds.

NOTE: If you are removing a standard carriage with forks, spread the forks

apart on the carriage shaft. This will provide the carriage adequate support

to stand alone.

4. Raise the quick attach pin lock lever and pull out the pin at the bot-

tom of the quick attach link (Figure 51).

Figure 51

5. Return to the operators compartment, fasten the seat belt and

lower the attachment to the ground in a level position. Tilt the

attachment forward. This will rotate the quick attach link back away

from the attachment.

6. Lower and then retract the boom until the attachment pivot pins

have disconnected from the attachment.

OS0331

Quick Attach Pin

Lock Lever