Manual

Operation
87
Model 10054 Rev 3/02
All approved forks for this vehicle are marked with a maximum load capacity
rating. This rating is stamped on the left edge of the fork just below the fork
pivot shaft (Figure 62). The rating is listed in U.S. pounds and based upon a
24" (610 mm) load center. This rating specifies the maximum load capacity
that the individual fork can safely carry at a maximum load center of 24"
(610 mm).
Since forks are always used in multiples, the total rating of any combination
of forks will be the sum of their rated capacity. Other than block forks, all
forks should be used in matched pairs. Block forks should be used in
matched sets.
Figure 62
The maximum load capacity for this vehicle is 10,000 pounds (4536 Kg).
The matched pair or set of forks used on this vehicle should have total load
ratings which equal or exceed 10,000 pounds (4536 Kg). When the load
rating of the vehicle differs from the load capacity of the forks, the lower
value becomes the overall load capacity.
Fork Ratings
WARNING: DO NOT exceed the total rated capacity of the
specific pair of forks being used. Forks can break causing loss of
load and possible death or serious personal injury to the operator
or personnel in the area. If the total rated capacity of the forks
exceeds
the capacity of the vehicle, the vehicle capacity should
not be exceeded.
24"
610 mm
5000 x 24
5000 x 24
OH0670
Stamped Load
Rating
Maximum 24"
Load Center
OH0670
Operation
87
Model 10054 Rev 3/02
All approved forks for this vehicle are marked with a maximum load capacity
rating. This rating is stamped on the left edge of the fork just below the fork
pivot shaft (Figure 62). The rating is listed in U.S. pounds and based upon a
24" (610 mm) load center. This rating specifies the maximum load capacity
that the individual fork can safely carry at a maximum load center of 24"
(610 mm).
Since forks are always used in multiples, the total rating of any combination
of forks will be the sum of their rated capacity. Other than block forks, all
forks should be used in matched pairs. Block forks should be used in
matched sets.
Figure 62
The maximum load capacity for this vehicle is 10,000 pounds (4536 Kg).
The matched pair or set of forks used on this vehicle should have total load
ratings which equal or exceed 10,000 pounds (4536 Kg). When the load
rating of the vehicle differs from the load capacity of the forks, the lower
value becomes the overall load capacity.
Fork Ratings
WARNING: DO NOT exceed the total rated capacity of the
specific pair of forks being used. Forks can break causing loss of
load and possible death or serious personal injury to the operator
or personnel in the area. If the total rated capacity of the forks
exceeds
the capacity of the vehicle, the vehicle capacity should
not be exceeded.
24"
610 mm
5000 x 24
5000 x 24
OH0670
Stamped Load
Rating
Maximum 24"
Load Center
OH0670