Service Manual User Manual

Cab, Covers and Mirrors
4-17
6. Connect all wire leads to the proper connectors on
the logic panel. Set the logic panel in its mounting
hole, but DO NOT secure with fasteners at this time.
7. Check all joystick functions for proper operation:
8. Start the engine and move the joystick handle
rearward, activating the boom hoist function. The
boom should raise or lift.
9. Move the joystick handle forward, activating the
boom lower function. The boom should go down.
10. Move the joystick handle to the right, activating the
boom extend function. The boom should extend.
11. Move the joystick handle to the left, activating the
boom retract function. The boom should retract.
12. If any of the functions fail to work as described, a
hydraulic hose is most likely connected to the wrong
joystick valve port. Relocate hoses as required to
attain proper joystick function.
13.
Current Production Vehicles
Align the joystick assembly mounting holes with the
console holes (Fig. 4–25). Secure the joystick
assembly to the side console with three flange-head
capscrews and lockwashers.
GO TO STEP 16.
Figure 4–25. For
Current Production Vehicles,
remove
the flange-head capscrews and lockwashers securing
the joystick assembly to the console.
14.
Early Production Vehicles
Use a one-inch (25mm) wooden block or other
suitable device to raise and hold the front dash (Fig.
4–26), allowing access to the underside of the
joystick. Install three flange-head capscrews through
the mounting holes in the base of the joystick
assembly and through the corresponding joystick
assembly mounting holes in the console.
Figure 4–26. Raise the dash with a wooden block and
install the fasteners to secure the joystick.
15. Reach through the logic panel opening and, from the
underside of the joystick, secure the flat washers,
lockwashers and long nuts to the flange-head
capscrews. Tighten all fasteners securely.
Figure 4–27. Secure the logic panel to the console
with four button-head capscrews.
16. Connect the wiring harness leads to the logic panel
terminal. Install the panel with the graphic symbols
oriented properly as viewed from the operator's
position. Secure the panel to the side console with
four button-head capscrews (Fig. 4–27).
SS1200
Joystick
Lockwasher
Flange-head
Capscrew
Flange-head
Capscrew
Joystick
Logic Panel
Opening
Front Dash
Wooden Block
"Long" Nut
Flat Washer
Lockwasher
SS1260
Button-head
Capscrew
Logic Panel
SS1210
Model 3606 • Origin 10/99