Service Manual User Manual

Section 4
4-18
Figure 4–28. Slide the boot onto the joystick.
17. Install the joystick boot (Fig. 4–28) by pulling the boot
over the joystick handle and down onto the base.
Properly seat the boot "lip" within the grooves in the
joystick base to help provide a water-tight seal.
Note: If any tie wraps were removed from the joystick
hydraulic hoses beneath the vehicle frame, bundle the
hoses and secure with new tie wraps as required to pre-
vent the hoses from contacting any sharp edges or mov-
ing parts.
18.
Current Production Vehicles
Wipe up any spilled hydraulic oil. This completes the
installation process for
Current Production Vehicles
.
19.
Early Production Vehicles
Move the seat all the way forward. Place the rear tool
bin (Fig. 4–29) into position within the cab. Align the
mounting holes at the front of the tool bin with the
corresponding holes in the front dash panel.
Figure 4–29. Install the fasteners
from inside the glove box.
20. Raise the armrest. From inside the glove box, install
the three capscrews, lockwashers and flat washers
and secure the tool bin to the right side of the cab, to
the right side cab wall, and to the front dash.
21. From the outside rear of the cab, secure the rear tool
bin (Fig. 4–30) to the cab with three flat washers,
lockwashers and hex-head capscrews.
Figure 4–30. Install the three hex-head capscrews,
lockwashers and flat washers
securing the rear tool bin to the cab.
22. From the outside rear of the cab (Fig. 4–31), secure
the outer rear panel to the cab with four plastic
washers and button-head capscrews.
Figure 4–31. Install the plastic washers and button-head
capscrews securing the outer rear panel to the cab.
23. Connect the wiring harness leads to the terminals of
the switches within the switch bezel (Fig. 4–32). Snap
the bezel into its console mounting hole.
Joystick
Boot
Base
SS1190
Rear Tool Bin
Capscrews,
Lockwashers
and Flat Washers
SS1240
SS1250
Rear Tool
Bin
Cab
Lockwasher
Flat Washer
Capscrew
Cab
Outer Rear
Panel
Plastic Washer
Button-head
Capscrew
SS1230
Model 3606
•
Origin 10/99