Service Manual User Manual

Section 8A
8A-20
2. Attach a suitable engine hoist to the engine lift plates
(Fig. 8A–21).
3. Carefully install the engine onto the engine mounts
(items 7, 8, 16, 17, 24 and 28, Fig. 8A–1). Make sure
the bracket-type engine mounts align properly with
the engine mounts in the subframe.
4. In four locations, install the nuts, washers and
capscrews securing the engine mounts (Fig. 8A–1) to
the hydraulic reservoir/engine mount subframe.
Torque the 7/16-14 x 3-1/4" Grade 8 capscrews to 60
lb/ft (81 Nm). Torque the 5/8-11 x 4" Grade 8
capscrews to 180 lb/ft (244 Nm).
5. Install the fan and/or radiator as required.
6. Connect the engine harness and hydraulic fluid-level
sending unit leads (Fig. 8A–22).
Figure 8A–22. Connect the engine harness lead to the
hydraulic fluid level sending unit lead.
7. Secure the throttle cable (Fig. 8A–20) to the bracket
located just above the starter.
8. Connect the throttle cable at the engine mount
bracket (Fig. 8A–20).
9. Connect the fuel inlet line to the fuel lift pump
(Fig. 8A–23).
Figure 8A–23. Fuel inlet line to lift pump connection.
10. Connect the fuel return line to the fuel injector
distributor (Fig. 8A–24).
Figure 8A–24. Connect the fuel return line to
the fuel injector distributor.
11. Connect the engine wiring harness leads to the steer
select valve leads (Fig. 8A–25).
Figure 8A–25. Connect the engine wiring harness leads to
the steer select valve leads.
12. Connect the engine wiring-harness bulkhead
connector to the bulkhead receptacle.
13. Working from beneath the vehicle, connect all engine
wire harness leads as necessary (refer to
Section 10
Electrical System
for detailed views of each
component). Secure the harness with tube clips and
plastic tie wraps as required to prevent the wiring
harness and wire leads from hanging below the
vehicle and from coming into contact with moving
parts.
14. If the engine and transmission were NOT installed as
a unit, attach the transmission to the engine at this
time. Refer to
Section 7 Transmission
.
Note: The drive shaft is a balanced assembly. The yokes
at each end of the drive shaft must be in the same plane
to help prevent excessive vibration (Fig. 8A–26).
MS3020
Hydraulic fluid
level sending
unit lead
Engine
harness
lead
Front of
vehicle
OA0332
Fuel lift pump
Fuel inlet line
OS0731
Fuel injector distributor
Fuel return line
MS1400
Steer select valve
Connect
Connect
Engine
wiring
harness
leads
Model 3606 • Origin 10/99