Service Manual User Manual

Section 10
10-52
Model 3606 • Origin 10/99
a. Power-Up Lights
When the ignition key switch is turned to power up the
vehicle, all lights in the display panel will illuminate for
three seconds as a test function. During this time, an
audible alarm will also sound.
The Fasten Seat Belt and Read Manual symbols (Fig.
10– 46) will remain illuminated for five to seven seconds
(repeated whenever the seat belt switch senses that
pressure is removed from the seat), reminding the opera-
tor to fasten the seat belt and to review the
Owners/Oper-
ators Manual
if there are any questions about safe and
proper operation of the vehicle (a manual should be kept
in the storage compartment beneath the seat at all
times).
Normal Operating Lights
After the engine starts, the operators display panel (Fig.
10– 46) provides information via the following indicators:
Figure 10– 46. The operators display panel indicators
illuminate when the vehicle is started.
A. Fuel Level Indicator Bars
Each of the fuel level indicator bars (Fig. 10– 46) repre-
sents approximately 1/4 tank. The vehicle must be
parked on a firm, level surface to ensure an accurate fuel
level reading. The fuel level indicator bars will be illumi-
nated with a low-light green hue, easily apparent for night
visibility and in low-light conditions. When approximately
1/8 tank is reached, the last fuel level indicator bar will
stop illuminating, and the fuel level indicator symbol, a
graphic of a fuel dispensing pump, will change from
green to orange. When the fuel level indicator symbol
changes from green to orange, refuel the tank.
B. Travel and Gear Select Indicators
These illuminate to show the direction the travel select
lever is in (F for FORWARD, N for NEUTRAL, and R for
REVERSE) and the gear presently engaged.
C. Steering Mode Indicators
The steering mode indicators (Fig. 10– 46) illuminate to
show which of the steering modes (front-wheel, crab, or
four-wheel steering) is presently engaged.
D. Attachment Tilt Mode Indicator
One of the two attachment tilt mode indicators will illumi-
nate to show which mode (extend/retract or raise/lower)
is presently engaged.
Function Indicator Lights
Figure 10– 47. Function indicator lights.
There are three subdued or "hidden" function indicator
lights (Fig. 10– 47) in the display panel that illuminate only
when a specific function is activated. They are:
A. Engine Preheat Indicator (Perkins engines only)
This light flashes when the ignition key is held in the
PREHEAT position (Fig. 10– 48). After 30 seconds, the
light will glow steadily, indicating the engine is warm
enough to start.
Figure 10– 48. Ignition key switch positions.
1
2
34
F
N
R
A
B
C
D
OS0211
Fuel
Indicator
Symbol
Travel Select
Indicators
Fuel Level
Indicator
Bars
Fasten Seat Belt
Gear Select
Indicators
Read
Manual
1
2
34
F
N
R
P
1
2
34
F
N
R
P
D
A
B
C
A
B
C
OS049
2
Early Production Operators Display
Current Production Operators Display
OF0390
OFF RUN
PREHEAT
START