Service Manual User Manual

Section 10
10-64
Model 3606 • Origin 10/99
d. Transmission Solenoid Valve Installation
1. Carefully install the four-way cartridge valve
assembly with four new O-rings (8, 9, 10 and 11, Fig.
10– 69) into the transmission. Always replace used O-
rings with new O-rings.
2. Install an O-ring (5) on each side of the 12-volt
solenoid coil (6). Always replace used O-rings with
new O-rings. Install the 12-volt solenoid coil onto the
cartridge valve (7).
3. Install the valve cartridge retainer nut (4) securing the
12-volt solenoid coil to the transmission.
4. Install the protective cover (1), lockwashers (2) and
cover screws (3) over the transmission solenoid
valves.
5. Refer to the chart listed earlier under
10.8.11
Transmission Solenoid Valves
. Connect the
transmission solenoid valve(s) with the proper wiring
connector(s).
6. Connect the negative (-) battery cable to the negative
battery terminal (Fig. 10– 70).
7. Test the operation of the transmission. Put the
transmission through its entire range of gears
(speeds) in both FORWARD (F) and REVERSE (R)
and check that the transmission also shifts into
NEUTRAL (N).
8. Verify that each function works properly, that the
transmission does not engage when in NEUTRAL
(N) and that the proper indicators illuminate on the
operators display panel.
For further transmission information, refer to
Section 7
Transmission
and to the
Clark-Hurth T 12000
transmis-
sion service manual.
Figure 10– 71. Disconnect the negative (-) battery cable
at the negative (-) battery terminal.
OS1040
Negative (-)
Terminal