Service Manual User Manual

Section 2
2-40
Figure 2–74. Prevent the clevis end from turning,
and tighten the extend chain locknut
at the rear of the outer boom.
5. Periodically measure the distance between the inner
boom and the intermediate boom. Repeat Step 4
until a distance of 2.5 inches (63,5 mm) is obtained
between the inner boom and the intermediate boom
(Fig. 2–72).
6. Tighten the retract chain locknut (Fig. 2–73) to 35-40
lb/ft (47,5-54,2 Nm).
7. Close and lock the rear cover.
2.12.18 Storage
A. Before Storing a Vehicle
Perform the following steps prior to placing the vehicle in
storage:
1. Clean the entire vehicle.
2. Lubricate all grease fittings.
3. Prepare the engine for storage (refer to the engine
manual).
4. Apply
LPS 3
(or equivalent) to all exposed hydraulic
cylinder rods.
5. Disconnect the battery cables. Remove the battery
from the vehicle and store it in a dry place not subject
to temperatures near or below freezing.
6. Preferably, store the vehicle inside where it will
remain dry. If it must be stored outside, park it on
lumber laid on flat, level ground, or on a concrete
slap. Cover the vehicle with a tarp.
B. Removing Vehicle From Storage
After removing the vehicle from storage and before oper-
ating it, perform the following steps:
1. Install a properly charged battery. Secure the hold-
down strip and attach the cables.
2. Change the engine oil and filter to remove
condensation or other residuals.
3. If the vehicle has been stored for two years or more,
drain the coolant from the engine block and radiator
and refill with a 50/50 mixture of fresh anti-freeze and
water.
4. Wipe off any
LPS 3
(or equivalent) applied to
exposed cylinder rods prior to storage.
5. Perform all recommended 10 hour maintenance
procedures.
2.12.19 Transport
When transporting the vehicle, make use of all four
tiedowns (Fig. 2–75).
Figure 2–75. When transporting the vehicle,
make use of all four tiedowns.
OS1440
Retract
Chain
Locknut
Clevis
End
B
A
VIEW IN DIRECTION OF ARROW B
VIEW IN DIRECTION OF ARROW A
OS2150
Vehicle Frame
(S/N 8084 and After)
Model 3606
•
Origin 10/99