Operation Manual

CAMERA SETUP continued
Alarm Service Settings (Motion Detection)
Enter the Alarm Service Settings page to configure the Motion Detection function. When you enable
motion detection, the camera can be triggered to send email alerts and upload images. In the
camera monitoring page, the green icons will turn to red and you will hear an alert sound if motion
is detected.
Motion Detection Sensitivity - You can choose a level from 1 to 10. The most sensitive is 10.
Input Pins - The input pins can be used for a 1-way external sensor input. For example, you can connect a
Passive Infrared Sensor (PIR) to it for motion detection. When an external sensor is triggered, the IP camera
can be programmed to send an email with an image snapshot or control the internal relay output. If you link a
external alarm with Pin3 and Pin4, and enable alarm input, the external alarm will be enabled.
Send Mail on Alarm- Sends picture & mail information to the set Email address after the alarm is triggered.
Upload Image on Alarm - Enable this function to upload an image after the alarm is triggered.
REC on schedule and save to PC - Enable this function for automatic recording to start on schedule for
several seconds and save to the PC if there is an alarm triggered.