User's Manual
Table Of Contents
- 1. INTENDED USE
- 2.SAFETY INFORMATION
- 3.Review
- 4 SPECIFICATIONS AND PARAMETERS
- 5 OPERATION DESCRIPTIONS
- 6 CLEANING AND DISINFECTION
- 7 MAINTENANCE
- 8 TROUBLESHOOTING
- 9 PRECAUTIONS
- 10 CONTRAINDICATIONS
- 11 EMC INFORMATION
- 13 LIMITED WARRANTY
- 14 DISPOSAL
- 15 COPYRIGHT AND RESPONSIBILITY
- 21 -
5.2.3 DEVICE BINDING
After the user log in, please follow the user guide of the APP to complete the device binding operation.
ATTENTION
1. When you bind the device, you need to use the mobile phone to scan the QR code on the label at
the back of the AI center.
2. If the bound AI center needs to be replaced, you must unbind it in the APP and then re-bind the
device.
5.2.4 NETWORK CONNECTION
Please follow the steps below to complete the WiFi network connection.
1. Plug the AI center into the charging base or charge it with the charging cable.
2. Make sure that your mobile phone’s Bluetooth is turned on.
3. Ensure that the AI center is in a WiFi environment, open “SKYWALK” APP and follow the instruction of
“Network connection” to complete the connection.
4. If the connection is successful, “Connection successful” will pop-up on “SKYWALK” APP.
5. If the connection fails, “Connection failed” will pop-up on “SKYWALK” APP, please follow the guide on
APP to reconnect.
ATTENTION
1. The device mus bt bound with your phone before configuring the WiFi connection.
2. AI Center should be in normal charging status while configuring the WiFi connection.
3. The WiFi network connection should be reconfigured if the wireless environment changes.
4. The device only supports 2.4G WiFi connection.
5.2.5 MODE CONFIGURATION
Before using the device, you must configure the nodes and AI center in advance. The product supports three
configuration modes: