User's Manual
Table Of Contents
- 1. INTENDED USE
- 2.SAFETY INFORMATION
- 3.Review
- 4 SPECIFICATIONS AND PARAMETERS
- 5 OPERATION DESCRIPTIONS
- 6 CLEANING AND DISINFECTION
- 7 MAINTENANCE
- 8 TROUBLESHOOTING
- 9 PRECAUTIONS
- 10 CONTRAINDICATIONS
- 11 EMC INFORMATION
- 13 LIMITED WARRANTY
- 14 DISPOSAL
- 15 COPYRIGHT AND RESPONSIBILITY
- 22 -
AI center
Laser nodes
Collector nodes
Waist/Cane Mode Configuration
1
1
2
Shoe Mode Configuration
1
2
0
* If the wearing mode is switched, the mode configuration must be changed.
Waist/Cane mode network status :
Shoe mode network status:
Please follow the steps below to complete the configuration of the AI center and each node of the device:
1. Specify the corresponding mode configuration according to the way you want to wear the device.
2. Plug the corresponding nodes and AI center into the charging base.
3. Make sure that mobile phone’s bluetooth is on.
4. Open “SKYWALK” in your mobile phone and follow the “Mode Configuration” guide to complete the node
configuration.
5. If the mode configuration is successful, “Configuration Successful” will pop-up on “SKYWALK” APP.
6. If the mode configuration fails, “Configuration failed” will pop-up on “SKYWALK” APP. Please follow the
APP guide to reconfigure.
ATTENTION
1. When configuring the mode, you must ensure that the AI center and nodes are in normal charging
state.
2. If you need to replace the configured AI compute center or node, the mode configuration must be
reconfigured.
3. If you need to switch other node configuration, the node configuration must be reconfigured.
4. Charge the nodes according to the number of nodes in wearing solution during mode configuration.
Do not charge the nodes which are not going to be configured simultaneously .