User's Manual

- 35 -
Guidance and manufacture’s declaration – electromagnetic immunity
The device is intended for use in the electromagnetic environment specified below. The customer or the user of the device should assure
that they are used in such an environment.
Immunity test
IEC/EN 60601 test level
Compliance level
Electromagnetic environment - guidance
Conducted RF
IEC/EN 61000-4-6
3 V
rms
150 kHz to 80 MHz
6 V
rms
in ISM bands between
0,15 MHz and 80 MHz
N/A
Portable and mobile RF communications device
should be used no closer to any part of the
device, including cables, than the recommended
separation distance calculated from the equation
applicable to the frequency of the transmitter.
Recommended separation distance
 
150KHz to 80MHz
Radiated RF
IEC/EN 61000-4-3
3 V/m
80 MHz to 2.7 GHz
See table 1
3 V/m
80 MHz to 2.7 GHz
Comply with table 1
 
80 MHz to 800 MHz
 
800 MHz to 2.7 GHz
d=6 /E at RF wireless communications
device bands (Portable RF communications
device (including peripherals such as antenna
cables and external antennas) should be used
no closer than 30 cm (12 inches) to any part of
the device, including cables specified by the
manufacturer).
Where P is the maximum output power rating of
the transmitter in watts (W) according to the
transmitter manufacturer and d is the
recommended separation distance in meters
(m).
Field strengths from fixed RF transmitters, as
determined by an electromagnetic site survey,
a
should be less than the compliance level in each
frequency range.
b
Interference may occur in the vicinity of device
marked with the following symbol:
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from
structures, objects and people.