Owner Manual

the first V-ring
clip
zipper loop
the first hole
Enclosure net
Enclosure door
Warning label (on mat top)
ID label (on mat back)
the first V-ring
the first hole
4.1
4.
4.2
4.3
Enclosure door
Warning label (on mat top)
ID label (on mat back)
Warning label (on mat top)
5
7
4
17
If the Enclosure net(7) and Jumping mat(5) are not
pre-installed, follow below steps to install.
Place the Jumping mat(5) on clear ground.Identify
the warning label on mat top and the ID label on
mat back as shown.
Place the Enclosure net(7) on the Jumping mat(5),
make sure the first hole and the first V-ring
arealigned as shown.
Insert the first V-ring into the first hole, and then-
insert the remaining V-rings into corresponding
holes in the same way one by one, until the Enclo-
sureNet(7) and the Jumping mat(5) are fully
attached .
NOTE:The first hole refers to the first one that is
located just left of the Enclosure door.The first
V-ring refers to the one that is located justleft of the
warning label near the ID label on Jumpingmat.