MINI Skywalker Mini Skywalker instruction manual Parts in the packing box are as follows: 1
Parts listing : 2
First we stick wing's carbon-fiber bracing sheet, evenly daub glue after waiting for 3 minutes, then press in formation.
Spread the glue evenly over the magnet and bonding surface,air dry for a few minutes and then compress tightly. Bonding the fuselage's high strength carbon fiber tube .
Spray the engine cover into black color 5
Bonding the rudder's steel tie rod components. It also needs to wait for 5 minutes until the glue is dry and then start to butt. Install the rudder and servo.
Spread the glue evenly on both sides of the fuselage and wait for 5 minutes,then stick, pay attention to the glue layer thickness cannot be too much.
Bonding the elevator servo Cut the slot on the servo lug. Install the tail plane Fix the rudder horn with AB glue and install the steel tie rod.
Install the aileron servo, and bond the servo wire Fix the servo wire with transparent adhesive tape Cut the slot on the aileron Bonding the rudder horn with AB epoxy resin , and adjust the length of the tie rod. Install the motor base, smear evenly on both sides with the glue in the accessories bag, wait until it is dry and then compress tightly.
Mini skywalker is suitable for AX1806N motor 10
Installation completes CG:35MM 11
