Instruction Manual LCD-32L8E 32" LCD TV/MONITOR SIZE:A5
SAFTY PRECAUTION Read all of the instructions before operating the set. Keep these instructions well for later use. PRODUCT The ventilation should not be impede by covering the ventilation openings with items, such as newspaper, table-cloths, curtains, etc. Do not push any objects of any kind into this unit through the cabinet slots as they could touch the current carrying parts or short-circuit parts, resulting in fire, electric shock, or damage to the unit.
SAFTY PRECAUTION USE ENVIRONMENT Do not install this equipment in a confined space such as a book case or similar unit. To prevent injury, this apparatus must be securely attached to the wall mount fastened on the wall. Place the set on a place that allows good ventilation. Do not use the set near damp, and cold areas, protect the set from overheating. Keep away from direct sunlight.
SETUP Insert The Batteries Remove the battery cover by pressing it and sliding it down. Insert the two 1.5V (AAA size) batteries making sure the polarity (+or -)of the batteries matches the polarity marks Inside the unit. Replace the battery cover by sliding it in until you hear a click sound. Precautions when using batteries Do not use old and new batteries together. Do not use different types of batteries (for example, manganese and alkaline batteries) together.
SETUP Locate the receiver in the room where direct light does not strike the screen. Total darkness or a reflection on the picture screen can cause eyestrain. Soft and indirect lighting is recommended for comfortable viewing. Allow enough space between the receiver and the wall to permit ventilation. Avoid excessively warm locations to prevent possible damage to the cabinet or premature component failure. This TV operates on AC supply directly, connect the AC plug to the socket at the back of the TV.
FUNCTIONAL PARTS Front Panel Note: The graphics are for representation only. 1 12 8 12 + ERAPHONE 4 - 10 11 5 MENU HDMI3 9 + PROG R -AUDIO- L 3 - VIDEO 3 VOL S-VIDEO 2 6 TV/AV 7 ON/OFF 1. POWER INDICATOR 2. REMOTE SENSOR 3. VOLUME UP/DOWN BUTTON 4. PROGRAM UP/DOWN BUTTON 5. MENU BUTTON 6. TV/AV BUTTON 7. ON/OFF BUTTON 8. S-VIDEO INPUT 9. AV3 INPUT 10. EARPHONE OUTPUT 11 HDMI3 INPUT 12.
FUNCTIONAL PARTS HDMI1 VGA VGA AUDIO 1 1 2 3 S/PDIF Pr 5 4 R - AUDIO - L VIDEO R - AUDIO - L VIDEO AV1 VIDEO Pb Y AV OUT L - AUDIO - R HDMI2 AV2 Back Panel 6 75 ANT 7 8 9 1. HDMI1\HDMI2: Connect HDMI input signal from signal source such as DVD. 2. VGA: Connect a PC via a VGA cable. 3. VGA AUDIO: Connect audio signal from PC. 4. Y Pb Pr(HDTV): Connect RCA cable to connect DVD player or other video device's YPbPr output. 5.
OPERATION INSTRUCTIONS Remote Control Unit POWER MUTE 1 POWER (STAND BY) BUTTON ( ) Press this button to turn the TV on/off. 2 MUTE BUTTON ( ) Press once to mute the sound, press again to return to preset sound level. 3 PROGRAM SELECTION BUTTONS (0-9) AV/TV You could select program you want with 0-9 button. For program up to 100-199, you need press three digit number quickly, then TV will go to the program directly.
OPERATION INSTRUCTIONS Remote Control Unit POWER 10 LEFT RIGHT ARROW/ZOOM-/+ (Z- / Z+) Press to change the screen format: 4:3 format, 16:9 format, 14:9 ZOOM, 16:9 ZOOM1, 16:9 ZOOM2. MUTE 11 OK BUTTON (OK) Press to enter selected item. / ) 12 CURSOR buttona( Left/Right/Up/Down direction keys for selecting menu itemsor signal sources. AV/TV RECALL SLEEP INFO VOL PROG 13 MENU BUTTON (MENU) Press this button to enter the menu screens for various Optional adjustable settings.
OPERATION INSTRUCTIONS Remote Control Unit POWER MUTE 21 PIP SOUND Press this button to select current sound output from main or PIP source when PIP is active . 22 PIP SIZE Press this button to change PIP picture size , Normal or Zoom when PIP is active . 23 TEXT BUTTON This button is used for entering the teletext MENU. AV/TV RECALL SLEEP INFO VOL MENU PROG EXIT PICTURE SOUND FAV.
SIZE SIZE REVEAL REVEAL Text You could stop it by press "HOLD" button . SUB.PAGE Up arrow key Down arrow key SUB.PAGE INDEX MIX MIX 1000 MIX So TV will display text page you required quickly .
Up arrow key Down arrow key To Cancel TEXT Press "CANCEL" button to clear the TEXT. But the page number is still displayed on the left top of the screen. NOTICE: However, Teletextis playing all the same on the background at the time. Press " CANCEL" button again to resume the TEXT. To Freeze TEXT Press "HOLD" button to hold a Text Page. This means the page will not change and refresh. Press the button again to release the hold state. To exit Teletext Press the " TEXT " or " EXIT" button.
ANALOG MENU SCREENS 1. Plug in the power cord and switch on power switch . The power indicator will light up. If TV is in stand by mode. Then Press"¡¡ " Key. The picture will display in few minutes. MENU BUTTON 1.Press menu button to display menu, and press left/right arrow key to select sub menu. PICTURE SOUND INSTALLATION TIMER PREFERENCE PARENTAL CONTROL 2.After entering an item, you can select the desired adjusting item by the up/down arrow key and adjust It by the left/right arrow key buttons.
ANALOG MENU SCREENS Sound Menu Enter Sound menu, you can select Sound Mode, Balance, Treble, Bass, Auto Volume Level. Items by pressing up/down arrow key. Sound Mode Press the left/right arrow key to select the audio mode. The audio mode are Standard, Music, Film, Voice, Personal. Balance Press the left/right arrow key to adjust to the left to right sound channel volume. Treble Press the left/right arrow key to adjust the high frequency signal value.
ANALOG MENU SCREENS Installation Menu Channel Name Display channel name, you could edit it if press "OK" to enter edit sub menu. use up/down arrow key to change name of program in the edit sub menu. Colour Sys Press the button to select a new colour standard value in TV. The choices are AUTO, PAL,NTSC and SECAM. Sound Sys Press the button to select a new sound standard value in TV. The choices are B/G, D/K, I, M. It's better to select it before auto installation.
ANALOG MENU SCREENS Time Menu Enter Timer menu, you could set time and turn on/off timer. With Time reference, you could set channel from which TV get teletext time. Current Time show the time of your TV remember, you could set this time manualy if you want. Otherwise, TV get it from channel for time reference . Turn off/Wake up time used for setting of TV turn off and/or wake up time according current time. you could select which channel you want when the TV wake up according wake up time.
ANALOG MENU SCREENS Parental Control Menu Enter Parental Control menu you can set control of it .Press left/right arrow key to select Parental Control item, then press up/down arrow key to entry menu. Input correct password to entry sub menu when PIN item is high light . The initial password is "0000". Lock Installation Press left/right arrow key to lock installation menu or unlock it. This item is only available in TV mode . Channel Number Press left/right arrow key to select channel which you want lock.
ANALOG MENU SCREENS PC Mode 15 Pin Mini D-Sub Connector and LCD TV. PC Input typical display modes. The following table is an illustration of some of the typical video display modes. 1 640X480(recommend 60Hz) 2 3 4 800X600(recommend 60Hz) 1024X768(recommend 60Hz) 480p 5 6 7 576p 720p(50/60Hz) 1080i(50/60Hz) Menu In PC Mode Enter menu by pressing the "MENU" button on the remote control.
ANALOG MENU SCREENS Preferences Menu Enter preferences menu you can setup the Language, Zoom, Film mode, OSD Transparent. Select preferences menu by press the up/down arrow key and enter the caption function by pressing left/right arrow key, you can adjust the Style function items by pressing left/right arrow key buttons. Language Press the left/right arrow key and MENU buttons to select the osd Language. Zoom The picture display will change as 4:3 format , 16:9 format , when you change Zoom setting.
ANALOG MENU SCREENS HDMI Input Resolutions HDMI Input typical display Modes. The following table is an illustration of some of typical Video display modes. 1 640X480(recommend 60Hz) 2 3 4 5 6 800X600(recommend 60Hz) 1024X768(recommend 60Hz) 480p 576p 720p(50/60Hz) 7 8 1080i(50/60Hz) 1080p(24/50/60Hz) YPbPr Mode(Component input) The menu of Y Pb Pr mode is exactly same as the menu of HDMI mode. YPbPr Input typical display modes.
Symptoms n Try d if fe re n t chann Check e l, if O a e ri a l K , p ro conne b a b ly Check c ti o n s s ta ti o n a e ri a l on bac tr o u b le fo k of se r b ro k e R e -o ri t n w ir e ent ae s ri a l (i f P ro b a in d o o r ty b ly lo c pe) a l in te A d ju s t rf e re n fi n e tu ce, su n in g c ch as a A d ju s t o n a p p li n tr o l b ri g h tn ance ess co A d ju s t n tr o c o n tr a l s t c o n tr Check ol if s ta ti o n is b A d ju s t ro a d c a c o lo u r s ti n g c c o n tr o l o lo u r Ch
