Install Instructions

Optional for additional support or necessary

where there is no element to rest on plastic

spacers:

Slide or

snap brackets

into groove

on bottom of

front panel.

6. Position new

assembled cover

with wall brackets

below element,

then slip new cover

over back panel.

Optional:

Screw brackets

to existing back

panel with

supplied

self-drilling

screws.

8. Attach end caps, corner pieces or chosen

accessories as required.

PREPARE EXISTING BASEBOARD

1 Remove old end caps.

2. Remove existing front panel.

3. Remove any existing damper sections.

PREPARE NEW ALUMINUM COVER

4. Set plastic cover spacers on top of

heating element

Quick Installation Guide

Appropriate gloves and eye protection should be worn during installation. For Use With Hydronic Baseboard Only!

Video Installation Intructions

You can watch a demonstration video of how

to install your new Revital/Line Replacement

Cover at www.slantfin.com

PAGE 1
® Quick Installation Guide Appropriate gloves and eye protection should be worn during installation. For Use With Hydronic Baseboard Only! PREPARE EXISTING BASEBOARD 1 Remove old end caps. 2. Remove existing front panel. 3. Remove any existing damper sections. PREPARE NEW ALUMINUM COVER 4. Set plastic cover spacers on top of heating element 5. Optional for additional support or necessary where there is no element to rest on plastic spacers: Slide or snap brackets into groove on bottom of front panel.