Instructions / Assembly

ManualsBrandsSlant/Fin ManualsHeater AccessoriesRevital/Line XL 5 ft. Hydronic Baseboard Cover in Bright White

Figure 3

Figure 2

Remove existing baseboard End Caps and

Inside Corner Pieces.(Figure 1).

Measure top to bottom of element, and end to end, and measure

depth from wall to oor of bracket with a tape measure. (Figures 2,3)

Remove the old baseboard Front Panel Cover by lifting from

the bottom to unhook from the bracket. Remove damper by

either sliding off from open end or by holding at each bracket

point and snapping off from the pivot. (Figures 4,5).

If the old baseboard length is the same as a standard length

Revital/Line XL

Cover, use the standard length Revital/Line

Cover and Solid End Caps.

All of the accessories are installed without tools by placing

them over the Revital/Line XL

Cover, once the cover is in

place. When more than one cover is used, the seam between

the covers can be hidden by using one of the ller sleeves (2",

4", 7" or 14"). All accessories are sold separately.

From the World’s Leader in Baseboard Heaters Since 1949! • www.slantn.com

BOILERS & BASEBOARD

Use to Revitalize your Aging Hydronic Baseboard!

Figure 1

Figure 4

Figure 5

Before You Order: Measure and Preparation

Now you’re ready to order your Revital/Line XL

Replacement Covers.

Go HERE to purchase from our selected distributors.

Remove

Front Panel

Important to wear safety glasses and gloves before removing old front panel, damper and accessories.

5/8”

3-3/4”

7-3/8”

(W)

MAXIMUM

Existing Back Panel (Wall)

to Front of Element

Revital/Line XL

Back Lip

MAXIMUM

Height from Top of

Back Panel to Base

of Element Bracket

8-15/16”

Height of

Revital/Line XL

End Cap

Summary of content (2 pages)

PAGE 1
XL ® XL Use to Revitalize your Aging Hydronic Baseboard! Before You Order: Measure and Preparation XL Important to wear safety glasses and gloves before removing old front panel, damper and accessories. 1. 2. Remove existing baseboard End Caps and Inside Corner Pieces.(Figure 1). ® 3-3/4” MAXIMUM Existing Back Panel (Wall) to Front of Element Measure top to bottom of element, and end to end, and measure depth from wall to floor of bracket with a tape measure.
PAGE 2
5. If the old baseboard cover length is a different size from a standard length Revital/Line XL® Cover, install the standard length Revital/Line XL® Cover sections together until you get the same length as the old baseboard cover. If you need additional length, you can add a 2", 4", 7" or 14" filler sleeve. Since the filler sleeves are telescoping, they will fill in less than their dimension size. Other accessories are available to finish your installation (Figure 6). 6.