Specification

Extendable snap-on
accessories
FILLER SLEEVE
fills gaps up to 12"
HINGED END CAP
allows 3" adjustment
HINGED WALL TRIM
allows 3" adjustment
HINGED VALVE COVER
allows up to 7" adjustment
HINGED INSIDE CORNER
90˚ or 135˚
OUTSIDE CORNER
The fullest range of snap-on
hinged accessories.
©Slant/Fin Corp. 2009. Printed in USA 809. Publication 80-10.
SLANT/FIN CORPORATION, Greenvale, N.Y. 11548. Phone: [phone]
Fax: [phone] • Canada: Slant/Fin LTD/LTEE, Mississauga, Ontario
www.slantfin.com
Multi/Pak
®
80
Element
“H”
“D”
H-1 3
15
⁄16"1
3
⁄4"
H-3 3
1
⁄2"1
5
⁄8"
H-4 3
1
⁄2"1
3
⁄4"
H-5X 3
13
⁄16"1
3
⁄4"
H-6X 3
29
⁄32"1
3
⁄4"
I=B=R Approved Hot Water Ratings
NOTE: Ratings are for element installed in Multi/Pak 80 baseboard enclosure as shown in
drawing, with damper open. Ratings are based on active finned length [3 in. less than overall
length] and include 15% heating effect factor. Use 4 gpm ratings only when flow is known to be
equal to or greater than 4 gpm, otherwise, 1 gpm ratings must be used.
COVER ASSEMBLY SPECIFICATIONS:
Furnish and install Multi/Pak 80 baseboard cover assembly as manufactured by Slant/Fin
Corporation, consisting of one-piece 22-gauge bottom galvanized steel, back and top panel, and one-
piece 18-gauge galvanized steel front panel, formed of cold rolled steel. Bottom and top edges of
back panel shall be formed to provide channels along entire length, to receive full-height support
brackets. Brackets shall be die-formed of electro galvanized, 16-gauge quarter-hard cold rolled steel,
for rigid bracing and spring locking. Bracket spacing within cover assembly shall not exceed 2 feet.
Slide-action expansion cradles, formed of polypropylene, shall be inserted between heating element
and support bracket. Cradles shall protect element bottom and sides from contact with brackets or
cover, confining element to free lateral expansion for noiseless operation. Room-control damper vane,
of quarter-hard cold rolled steel, shall be provided for each length of enclosure, and shall modulate
fully and freely, yet retain any setting through its arc. Support bracket shall be formed to retain and
support damper vane. All cover components shall be painted in Nu-White oven baked melamine
cross-linked polyester enamel.
Cover Assembly
Universal enclosure for use with any H-Series heating element
Length, ft.
2 - 3-1/2 4 - 5 8 - 9 10 12 - 14
Brackets
2 2 4 6 8
Brackets Per Length (Complete assembly and enclosure only)